Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Analysis of the cause of the 40Hz frequency component in spiral casing of a high-head pump turbine

A Simulation Study of Hydraulic Vibration caused by Clearance Flow in a Pump Turbine

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Pressure pulsation in small opening operating mode of pump turbine’s turbine mode

Vibration and noise of a high head pump turbine: analysis and improvement

Analysis of axial force and pressure pulsation of centrifugal pump as turbine impeller based on dynamic mode decomposition

Mechanism analysis of the abnormal head-cover vibration of an ultra-high-head pump-turbine operating in pump mode by CFD and FEM

A Review of Fluid-Induced Excitations in Centrifugal Pumps

Analysis of the Guide Vane Jet-Vortex Flow and the Induced Noise in a Prototype Pump-Turbine

Model experimental study on special frequency of hydraulic pump working condition headcover for ultra-high head pump-turbine

Vibration Characteristic Analysis of Pump-turbine head cover based on Fluid-Solid Coupling

Special Pressure Fluctuation analyse of the pump turbine

High-amplitude Pressure Pulsations Induced by Complex Inter-Blade Flow During Load Rejection of Ultrahigh-Head Prototype Pump Turbines

Pressure pulsation of pump turbine at runaway condition based on Hilbert Huang transform

Vibration analysis of a high-pressure multistage centrifugal pump

Vibration and fatigue caused by pressure pulsations originating in the vaneless space for a Kaplan turbine with high head

Analysis of Internal Flow Characteristics of a Startup Pump Turbine at the Lowest Head under No-Load Conditions

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Analysis of the Pressure Pulsation and Vibration in a Low-Specific-Speed Centrifugal Pump

Dynamic Characteristic Analysis of a Pump-Turbine Unit under the High Pressure Pulsation Operating Condition - Fluid Dynamics Analysis