Potential of thermal protection improvements in large-scale cryostat development
M.K. Singh,V. Singh,K. Saraswat,D. Singh
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.126254
IF: 5.2
2024-10-06
International Journal of Heat and Mass Transfer
Abstract:Tremendous efforts are being pursued by experimentalists worldwide in the designing of cryostats to minimize the most dominant radiation heat load over the cryogenic liquid kept inside it. These endeavors are imperative to secure the safe, consistent, and reliable performance of detectors, notably for experiments delving into the investigation of rare physics events, particularly those moving towards ton-scale capacities. In these experiments, maintaining a stable temperature of the cryogenic liquid is crucial. This stability helps in minimizing thermal noise and reducing the loss of cryogenic liquid by mitigating its evaporation rate, and this can be accomplished by reducing the ambient heat load coming from the outer hot wall towards the inner cold wall of the cryostat. Current work scrutinized the impacts of having no insulation, a single-layer insulation, and Multilayer Insulation (MLI) techniques on thermal protection from environmental heat loads at the cryostat's cold wall boundary, with a particular emphasis on the effectiveness of a single-layer insulation strategy against radiative heat load , a key precursor to MLI technology. The effectiveness of single-layer insulation was quantitatively analyzed for reducing heat load in large-scale rare event searches, using GERDA as an illustrative example and focusing on an optimized configuration. Performance metrics include ambient temperature, cryogenic liquid, emissivity, and the placement of insulation for optimal efficiency. The incorporation of a single intermediate layer positioned near the cold wall boundary results in a significant heat load reduction of 57% for the GERDA geometry compared to a scenario without such a layer. A feasible decrease in emissivity from the customary O (0.01) for insulation materials down to O (0.001–0.0001) could bring about substantial reductions in heat load, potentially by factors spanning approximately 8 to 90. In the scenario involving liquid helium (4.15 K), for example, as the ambient temperature surrounding the cryogen is lowered to (200, 150, 100, 50) K from room temperature, the heat load diminishes by 80%, 94%, 98.8%, and 99.9%, respectively. Moreover, optimally positioning single intermediate layer, crafted from ultra-radiopure material, as close as achievable to the cold wall boundary with minimal emissivity can yield a substantial reduction in heat load, estimated ∼ (40–60)%, thereby diminishing the evaporation rate of the cryogenic liquid.
engineering, mechanical,thermodynamics,mechanics