Abstract:A series of characterizations (including in situ X‐ray diffraction, in situ Raman, X‐ray photoelectron spectroscopy, scanning electron microscope) and electrochemical tests (in situ electrochemical impedance spectroscopy, open‐circuit potential) together with density‐functional theory calculation consistently demonstrate that the in situ photoelectrochemical (PEC) activation promotes the surface reconstruction of BiVO4 photoanodes with greatly increased {040} crystal face and vanadium/oxygen vacancies and finally boosts PEC performance. BiVO4 has been widely concerned due to its great potential in photoelectrochemical (PEC) water splitting. However, low carrier mobilities and high recombination efficiency of photogenerated carriers impede its photocatalytic performance. Herein, an in situ PEC cyclic‐voltammetry‐induced surface reconstruction of BiVO4 photoanodes (BVO pristine) is developed with significantly enhanced efficiency for solar water splitting. A series of in situ characterizations (including in situ X‐ray diffraction, in situ Raman), together with electrochemical tests and density‐functional theory calculations, reveal that during the photoelectrical activation process, the BVO pristine surfaces undergo a crystal plane reconstruction with greatly increased {040} crystal face to promote the separation of photogenerated carriers. In addition, abundant vanadium vacancies and oxygen vacancies are also introduced into the BiVO4 surface during the crystal face reconstruction process with more favorable surface water adsorption and increased injection efficiency of photogenerated carriers. Therefore, the charge‐transfer resistance (Rct) between BVO pristine and electrolyte under AM 1.5G illumination substantially reduced from the original 15 200 to 2820 Ω after the activation. Moreover, the photocurrent density of activated BVO pristines increases more than 12 times, relative to the original BiVO4. In this work, a new horizon for in situ photoelectric activation of semiconductor photoelectrodes with significantly enhanced PEC water splitting is provided.

Creation of oxygen vacancies to activate 2D BiVO4 photoanode by photoassisted self‐reduction for enhanced solar‐driven water splitting

Dual Modification of BiVO4 Photoanode by Enriching Bulk and Surface Oxygen Vacancies for Enhanced Photoelectrochemical Performance.

BiVO4 photoelectrodes for unbiased solar water splitting devices enabled by electrodepositing of Cu2O simultaneously as photoanode and photocathode

New BiVO4 Dual Photoanodes with Enriched Oxygen Vacancies for Efficient Solar-Driven Water Splitting

Photochemically Etching BiVO4 to Construct Asymmetric Heterojunction of BiVO4/BiOx Showing Efficient Photoelectrochemical Water Splitting

High-Performance Ultrathin BiVO4 Photoanode on Textured Polydimethylsiloxane Substrates for Solar Water Splitting

Interface Modulation of BiVO4 Based Photoanode with Bi(III)Bi(V)O4 for Enhanced Solar Water Splitting

Integration of surficial oxygen vacancies and interfacial two-dimensional NiFe-layered double hydroxide nanosheets onto bismuth vanadate photoanode for boosted photoelectrochemical water splitting

Tailoring Carrier Dynamics of BiVO4 Photoanode via Dual Incorporation of Au and Co(OH)x Cooperative Modification for Photoelectrochemical Water Splitting

Boosting the Performance of BiVO4 Photoanodes by the Simultaneous Introduction of Oxygen Vacancies and Cocatalyst Via Photoelectrodeposition.

Ni-Doped BiVO4 photoanode for efficient photoelectrochemical water splitting

In Situ Photoelectrochemical‐Induced Surface Reconstruction of BiVO4 Photoanodes for Solar Fuel Production

Oxygen Vacancies Enhanced WO 3 /BiVO 4 Photoanodes Modified by Cobalt Phosphate for Efficient Photoelectrochemical Water Splitting

Fabrication of Fe2O3/BiVO4 heterojunction by doping method to improve the solar water splitting performance of BiVO4

Oxygen Vacancies Enhanced WO3/BiVO4 Photoanodes Modified by Cobalt Phosphate for Efficient Photoelectrochemical Water Splitting

Charge Transport Enhancement in BiVO4 Photoanode for Efficient Solar Water Oxidation

BiVO4/CuBi2O4 heterojunction photoanodes with enhanced charge separation for efficient photoelectrochemical water splitting

Dramatically enhanced solar-driven water splitting of BiVO4 photoanode via strengthening hole transfer and light harvesting by co-modification of CQDs and ultrathin β-FeOOH layers

Nanostructured BiVO4 Photoanodes Fabricated by Vanadium-infused Interaction for Efficient Solar Water Splitting

Bismuth Vacancies Induced Lattice Strain in BiVO4 Photoanodes Boosting Charge Separation For Water Oxidation

Boosting charge separation and transfer at the boron-triggered BiVO 4 interface for efficient and stable solar water splitting