Abstract:Large-diameter monopiles are the predominant foundation solution for supporting offshore wind turbines. They are conventionally designed using soil reaction curves developed for long slender piles used for supporting offshore oil and gas platforms (e.g., the API p-y model). However, due to the difference in the length/diameter ratio and the resulting soil mechanisms, the use of p-y curves alone can lead to significant under-prediction of the lateral stiffness and capacity of monopiles. To overcome the shortcoming, the authors have previously proposed a conceptual two-spring framework, i.e., the so-called 'p-y + M-R-theta(R)' model, to capture the monopile response in soft clay under lateral loading. The framework uses distributed p-y springs to consider the lateral soil resistance along the pile above the rotation point (RP) and a single moment-rotation (M-R-theta(R)) spring attached at the RP to capture the entire soil resistance below the RP, i.e., the distributed resistance along the pile, base shear and base moment at the pile tip. The proposed p-y and M-R-theta(R) springs were curve-fitted to the results of 3D numerical analyses. However, as the stress-strain response and the shear strength profile inevitably influence the p-y and M-R-theta(R) springs, the applicability of the empirical formulations to soil conditions other than those examined is uncertain. This study proposes an enhancement to the 'p-y + M-R-theta(R)' framework, in which the p-y and M-R-theta(R) springs are not tied to a specific soil and strength profile but fundamentally linked to the properties that can be measured directly in the site investigation and laboratory. This extension is achieved through analytical analyses and an extensive parametric numerical study. The predictive capabilities of the model are demonstrated by back-analyses of finite element analyses and centrifuge model tests. The proposed model provides practising engineers with a simple yet powerful approach to use site-specific soil reaction curves in the design of monopiles embedded in soft clay.

Winkler spring coefficients for laterally loaded piles

Dynamic response analysis for a single pile subjected to lateral loading

An Analytical Solution for Lateral Vibration of a Pile with Finite Length Pile in Viscoelastic Subgrade

ANALYTICAL THEORY OF LATERAL VIBRATION OF SINGLE PILE IN VISCO-ELASTIC SUBGRADE CONSIDERING SHEAR DEFORMATION

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Axial Winkler springs for vertically loaded piles

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Timoshenko Beam Theory–based Analytical Solution of Laterally Loaded Large-Diameter Monopiles

Elastoplastic Analytical Computation of Long Piles under Combined Lateral Loads

Influence of Pile Diameter and Aspect Ratio on the Lateral Response of Monopiles in Sand with Different Relative Densities

Research on the laterally loaded piles under huge moment based on Lagrange multipliers method

A Simple Rotational Spring Model for Laterally Loaded Rigid Piles in Sand

Site-specific soil reaction model for monopiles in soft clay based on laboratory element stress-strain curves

A Unified Lateral Soil Reaction Model for Monopiles in Soft Clay Considering Various Length-to-diameter (L/D) Ratios

Numerical study on soil springs stiffnesses of laterally loaded monopiles

A Winkler model approach for vertically and laterally loaded piles in nonhomogeneous soil

Lateral static stiffness of offshore monopile socketed in soft rock

Quantifying the Influence of Pile Diameter on the Load Transfer Curves of Laterally Loaded Monopile in Sand

Field and Numerical Study of the Lateral Response of Rigid Piles in Sand