Joint Meeting of the Greek and Italian Sections of The Combustion Institute A NOVEL DIAGNOSTIC TECHNIQUE FOR “IN-SITU” CHARACTERIZATION OF COAL PYROLYSIS KINETICS IN GAS-FLUIDIZED BEDS

A. Marzocchella,R. Chirone,R. Solimene,P. Salatino

Abstract:Characterization of devolatilization kinetics in fluidized bed combustors/gasifiers is relevant to the assessment of the fate of volatile matter as it results from competing phenomena of VM release, mixing/segregation and burn-out. Despite the extensive literature on this subject, there is still a vigorous debate on the mechanisms controlling the release of volatile matter under fluidized bed processing conditions and on its relevance to the reactor performance. Uneven axial and radial distribution of volatile matter in the fluidized bed combustor is commonly experienced in industrial units and is reflected by uneven heat release as well pollutant emission. The amount and the time-history of volatile matter emission determines the formation of volatile bubbles (endogenous bubbles) that dramatically enhance the axial segregation of fuel particle favouring the establishment of the so called stratified combustion regime [1]. On the other hand, the comparison between the devolatilization time and the radial solids mixing time emphasizes the importance of devolatilization kinetics on the radial distribution of volatile matter in the reactor [2-3]. The complexity of phenomena associated with thermal degradation of coal, involving chemical reaction at the same time as heat and mass transfer phenomena, is well known [4-5]. Devolatilization of fine particles tends to be controlled by the intrinsic kinetics of pyrolytic reactions, whereas for coarse particles the propagation of temperature waves into the particle, controlled by thermal diffusion, becomes the dominant mechanism. A multiple-reaction model based on a continuous distribution of activation energies (DAEM) is often adopted [6]. The transition between the two regimes is critically dependent on the heating rate. Under this respect it is worth recalling that external heat transfer is very efficient in fluidized bed reactors, yielding heating rates as large as s K 10 4 − 10 . Different experimental diagnostic techniques have been used to evaluate the devolatilization time of coal particles in fluidized bed reactors. The flame period and flame extinction time techniques are based on the observation of volatile flames around the devolatilizing fuel particles [7]. The most common method consists of the analysis of the time-resolved CO and CO2 concentration profiles during devolatilization [8]. The time period between fuel particle injection and the time at which the centre of the particle reaches the bed temperature was also assumed as a measure of the devolatilization time [9]. More recently, the possibility to correlate the pressure increase measured in fluidized bed reactor associated with volatile matter emission was investigated [10]. In all the cases the experimental data were analyzed in the light of their dependence on the initial particle size, most commonly expressed by means of a power law equation. The exponent of the power law reflected the controlling mechanism. This work aims at developing a novel diagnostic technique for “in-situ” characterization of coal pyrolysis in gas fluidized beds based on the time-resolved measurement of pressure in a bench scale fluidized bed equipped with a calibrated flow restriction at the exhaust. Pressure time series are analyzed to yield the devolatilization rate as a function of time by means of a purposely developed model of the experiment.

Engineering,Environmental Science,Chemistry