Abstract:Numerical simulations of rail wear during sliding contact pose significant challenges owing to the complex coupling between thermomechanical contact loads, material properties , and profile changes. This study proposes a modeling approach for rail wear during sliding contact, using nonlocal peridynamic (PD) thermomechanics and a bond damage criterion based on ratchet failure. To facilitate test verification, a two-dimensional PD model for twin-disc testing with elastoplastic materials was developed, and numerical simulations and corresponding twin-disc testing were performed during wheel idling under different loads, idling speeds, and idling times. The PD model accurately predicted rail wear under all operating conditions, exhibiting excellent agreement with the test results, and thus validating the proposed method and supporting the ratchet failure mechanism. Subsequently, thermomechanical modeling of sliding contacts with different creepages was performed. The PD model predicted continuous wear along the contact surface, with an increase in wear depth corresponding to higher creepage values. As the contact temperature increased with creepage, thermal stress and thermal softening caused slight and sharp increases in rail plastic strain, respectively. Therefore, thermal softening is the main factor responsible for the significant increase in wear rate with temperature. Finally, wear results of the PD model and classical Archard's wear model were compared. The PD models can capture variations in wear rates that are difficult to address using the Archard model.

Study of Gouging Phenomena During Hypervelocity Sliding Contact Based on Smoothed Particle Hydrodynamics

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

3D numerical research of railgun gouging mechanism based on material point method

Study on the Influence of Micro-Features in the Surface Topography of the Slider Raceway on the Dynamic Friction Factor of the Guide Rail Pair

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Experimental Investigation on the Wear and Damage Behaviors of Machined Wheel-Rail Materials under Dry Sliding Conditions

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

An investigation into Belgrospi-like damage formation on a sharp curved track using finite element method

Effect of gauge corner lubrication on wheel/rail non-Hertzian contact and rail surface damage on the curves

Peridynamic modeling of rail wear during sliding contact considering thermal effects

Discrete Element Simulation of Fracture Surface Damage and Gouge Particle Evolution in a Rock Fracture Segment

Wheel-rail contact wear analysis on curved lubricated track for heavy haul locomotive studies

Experimental Study on the Skidding Damage of a Cylindrical Roller Bearing

Gouge Particle Evolution in a Rock Fracture Undergoing Shear: a Microscopic DEM Study

Analysis of the dynamic contact behaviour of high-speed train transmission gear excited by wheel defects

Effect of Surface Topography of Scraped Machine Tool Guideways on Their Tribological Behaviour

Simulation of Delamination Evolution of Slab Ballastless Track under Vertical Impact

Numerical investigation on wheel-rail impact contact solutions excited by rail spalling failure

Effect of material non-uniformity and residual stress on wear and transient rolling contact behaviour in laminar plasma quenched (LPQ) rails

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Smoothed particle hydrodynamics with kernel gradient correction for modeling high velocity impact in two- and three-dimensional spaces