Abstract:Conventional fluids used in fission‐based water‐cooled nuclear reactors have lower heat transfer coefficients and thermal conductivity, prompting researchers to explore high‐performance fluids to enhance heat transfer and prevent core meltdown during accidents. It is crucial to investigate fluids that can improve thermal hydraulic characteristics, such as the heat transfer coefficient, critical heat flux (CHF), and minimum departure from nucleate boiling ratio (MDNBR). This study investigates the effectiveness of nanofluids in enhancing heat transfer parameters, including thermal conductivity and heat capacity. Results indicate that the silver water nanofluid outperformed the other nanofluids and pure water. The silver water nanofluid demonstrated a 67.15 % improvement in the average heat transfer coefficient and a 45.23 % enhancement in MDNBR compared to pure water. This study underscores the promise of nanofluids, particularly Ag–H2O, in enhancing the thermal performance and safety of water‐cooled nuclear reactors. Future research should continue to explore various nanofluids and their applications to further optimize reactor design and operation, ensuring both efficiency and safety in nuclear energy production. Conventional fluids used in fission‐based water‐cooled nuclear reactors have lower heat transfer coefficients (HTCs) and thermal conductivity, which has led researchers to explore high‐performance fluids that can enhance heat transfer in routine operation and prevent core meltdown in the case of accidents. It is important to investigate a wide range of fluids that can help designers improve thermal hydraulic characteristics, such as HTC, critical heat flux, and minimum departure from nucleate boiling ratio (MDNBR). In this study, the effectiveness of nanofluids in enhancing heat transfer parameters, including thermal conductivity and heat capacity, was investigated. Four different nanofluids (Al2O3–H2O, ZrO2–H2O, Ag–H2O, and Si–H2O) with pure water as the primary coolant in an HPR‐1000 nuclear reactor were compared using computational methods. Due to computational limitations, only the flow channel among four fuel rods with the highest power density in the core was simulated using Eulerian computational fluid dynamics. The results of this study show that silver water (Ag–H2O) nanofluid outperformed other nanofluids and pure water. It had a higher average HTC and MDNBR, with a 67.15 % and 45.23 % improvement, respectively, compared to pure water. The fuel rod wall temperature was also reduced by 28.5 K with Ag–H2O compared to water. Comparison of current simulated results with literature data shows a good agreement.

Technical and economic evaluation of heat transfer fluids for a TES system integrated to an advanced nuclear reactor

Thermal insulation for a high temperature molten salt storage tank in a CSP plant

Thermodynamic calculations and experimental studies of ternary molten salts for high-temperature thermal energy storage

Optimized dispatch and component sizing for a nuclear-multi-effect distillation integrated energy system using thermal energy storage

CFD investigating thermal-hydraulic characteristics of FLiNaK salt as a heat exchange fluid

Survey and evaluation of equations for thermophysical properties of binary/ternary eutectic salts from NaCl, KCl, MgCl2, CaCl2, ZnCl2 for heat transfer and thermal storage fluids in CSP

Performance analysis of integrated Nuclear-Solar Energy system sharing same molten salt thermal energy storage

Properties and Heat Transfer Coefficients of Four Molten-Salt High Temperature Heat Transfer Fluid Candidates for Concentrating Solar Power Plants

Impact of the Heat Transfer Fluid in a Flat Plate Phase Change Thermal Storage Unit for Concentrated Solar Tower Plants

Thermal property characterization of a low melting-temperature ternary nitrate salt mixture for thermal energy storage systems

Design and Performance Evaluation of a New Thermal Energy Storage System Integrated Within a Coal-Fired Power Plant

Thermal Properties of NaF–KF and NaF–KF–MgF2 Molten eutectic Mixtures: Experiment and Simulation

Binary and Ternary Nitrate Solar Heat Transfer Fluids

Long-Term Evaluation of a Ternary Mixture of Molten Salts in Solar Thermal Storage Systems: Impact on Thermophysical Properties and Corrosion

Numerical prediction of the heat transfer properties of Flinabe molten salt as a coolant in a nuclear system

Thermal and Economic Evaluation of Thermocline Combined Sensible-Latent Heat Thermal Energy Storage System for Medium Temperature Applications

Improved Heat Transfer Capabilities of Nanofluids—An Assessment Through CFD Analysis

THERMAL PHYSICS OF ALKALINE LIQUID METAL COOLANTS. PART 2: PHYSICAL CHEMISTRY, TECHNOLOGY AND INNOVATIVE APPLICATIONS (RETROSPECTIVE-PERSPECTIVE VIEW)

Evaluation of the calcium chloride-calcium fluoride system for high temperature thermal energy storage

Development and characterization of a quaternary nitrate based molten salt heat transfer fluid for concentrated solar power plant

Steady Thermal Hydraulic Analysis for a Molten Salt Reactor