Abstract:In the present study, a molten salt solar power tower (SPT) system integrated with a S-CO2 Brayton cycle is presented. An integrated model is developed for the integrated SPT system including the heliostat field, the molten salt solar receiver, the molten salt thermal storage, and the S-CO2 recompression Brayton cycle with reheating. Parametric analysis is conducted to investigate the effects of some key thermodynamic parameters (e.g. hot salt temperature, cycle high pressure, cycle low pressure, intermediate pressure, and the split ratio) on the integrated SPT system in terms of exergy efficiency. The parameter optimization is performed by using genetic algorithm in order to obtain the highest overall exergy efficiency. The effects of the component performance and the compressor inlet temperature on the optimum parameters are also discussed. The results indicate that the optimum hot salt temperature is 565 degrees C which is its maximum allowable temperature when the solar salt is used as the heat transfer fluid and the thermal storage media. Besides, the optimum cycle low pressure is in the range of 7.80-10.0 MPa which means that the cycle low pressure is not mandatory to be close to the critical pressure. The increase in the compressor inlet temperature leads to both the decrease in maximum exergy efficiency and the variation of the optimum thermodynamic parameters. The component performances have significant effects on the maximum exergy efficiency, but slight effects on optimum thermodynamic parameters. A novel salt with a higher maximum allowable temperature is indispensable for further improving the system efficiency. The maximum allowable temperature of 680 degrees C is recommended for novel salts to be used in the SPT system integrated with S-CO2 recompression Brayton cycle from the viewpoint of exergy efficiency under the present conditions. (C) 2016 Elsevier Ltd. All rights reserved.

Evaluation of alternative eutectic salt as heat transfer fluid for solar power tower coupling a supercritical CO2 Brayton cycle from the viewpoint of system-level analysis

Thermodynamic Analysis and Optimization of a Molten Salt Solar Power Tower Integrated with a Recompression Supercritical CO2 Brayton Cycle Based on Integrated Modeling

Properties and Heat Transfer Coefficients of Four Molten-Salt High Temperature Heat Transfer Fluid Candidates for Concentrating Solar Power Plants

Entropy Generation and Carnot Efficiency Comparisons of High Temperature Heat Transfer Fluid Candidates for CSP Plants

Thermodynamic performance analysis of different supercritical Brayton cycles using CO2-based binary mixtures in the molten salt solar power tower systems

Thermophysical Properties Experimentally Tested for NaCl-KCl-MgCl2 Eutectic Molten Salt as a Next-Generation High-Temperature Heat Transfer Fluids in Concentrated Solar Power Systems

Performance Comparison of Three Supercritical CO2 Solar Thermal Power Systems with Compressed Fluid and Molten Salt Energy Storage

Performance Investigation of Solar Tower System Using Cascade Supercritical Carbon Dioxide Brayton-steam Rankine Cycle

Experimental Test of Properties of KCl–MgCl2 Eutectic Molten Salt for Heat Transfer and Thermal Storage Fluid in Concentrated Solar Power Systems

Assessing the performance of novel molten salt mixtures on CSP applications

Thermal properties of KCl–MgCl2 eutectic salt for high-temperature heat transfer and thermal storage system

Feasibility Research on a Hybrid Solar Tower System Using Steam and Molten Salt As Heat Transfer Fluid

Thermal Stability Calculation and Experimental Investigation of Common Binary Chloride Molten Salts Applied in Concentrating Solar Power Plants

Impact of the Heat Transfer Fluid in a Flat Plate Phase Change Thermal Storage Unit for Concentrated Solar Tower Plants

Effects of fluoride salt addition to the physico-chemical properties of the MgCl2–NaCl–KCl heat transfer fluid: A molecular dynamics study

Integration between supercritical CO2 Brayton cycles and molten salt solar power towers: A review and a comprehensive comparison of different cycle layouts

Thermal performance and economic evaluation of NaCl–CaCl2 eutectic salt for high-temperature thermal energy storage

Multi‐objective optimization of a novel supercritical CO2 cycle‐based combined cycle for solar power tower plants integrated with SOFC and LNG cold energy and regasification

Molecular dynamics simulation of thermophysical properties of NaCl-KCl phase change materials applied to concentrating solar power

Thermodynamic analysis of CO2-SF6 mixture working fluid supercritical Brayton cycle used for solar power plants

Thermodynamic calculations and experimental studies of ternary molten salts for high-temperature thermal energy storage