Further Investigation of CO2 Quasi-Dry Fracturing in Shale Reservoirs—An Experimental Study
Zheng,Tang,Wang,Li,Shen,Wang,Hu,Deng,Wu,Xi,Liu
DOI: https://doi.org/10.3390/pr12050912
IF: 3.5
2024-04-30
Processes
Abstract:The physical properties of shale reservoirs are typically poor, necessitating the use of fracturing technology for effective development. However, the high clay content prevalent in shale formations poses significant challenges for conventional hydraulic fracturing methods. To address this issue, CO2-based fracturing fluid has been proposed as an alternative to mitigate the damage caused by water-based fracturing fluids. In this paper, the applicability of quasi-dry CO2 fracturing in shale reservoirs is examined from three key perspectives: the viscosity of CO2 fracturing fluid, the fracture characteristics induced by the CO2 fracture fluid, and the potential reservoir damage caused by the fracturing fluid. Firstly, the viscosity of CO2 fracturing fluid was determined by a rheological experiment. Rheological tests revealed that the viscosity of CO2 fracturing fluid was significantly influenced by the water–carbon ratio. Specifically, when the water–carbon ratio was 30:70, the maximum viscosity observed could reach 104 mPa·s. Moreover, increasing reservoir temperature resulted in decreased fracturing fluid viscosity, with a 40 °C temperature rise causing a 20% viscosity reduction. Secondly, matrix permeability tests were conducted to investigate permeability alteration during CO2 fracturing fluid invasion. Due to the weak acidity of CO2-based fracturing fluid, the permeability reduction induced by clay hydration was inhibited, and an increase in permeability was observed after a 3-day duration. However, the matrix permeability tends to decrease as the interaction time is prolonged, which means prolonged soaking time can still cause formation damage. Finally, triaxial fracturing experiments facilitated by a three-axis servo pressure device were conducted. The fracture properties were characterized using computed tomography (CT), and 3D reconstruction of fractured samples was conducted based on the CT data. The results demonstrate that CO2 fracturing fluid effectively activates weak cementation surfaces in the rock, promoting the formation of larger and more complex fractures. Hence, CO2 quasi-dry fracturing technology emerges as a method with significant potential, capable of efficiently stimulating shale reservoirs, although a reasonable soaking time is necessary to maximize hydrocarbon production.
engineering, chemical