Abstract:This paper presents an experimental and numerical study of the distributions of the temperature and soot volume fraction in laminar coflow ethylene diffusion flames burning in O-2/N-2 and O-2/CO2 atmospheres with the O-2 mole fraction varying from 21 to SO% in both atmospheres. The fuel flow rate was maintained constant in all of the experiments and simulations. The two-color flame emission method based on the response spectrum of R and G bands of a three-color charge coupled device camera was applied to measure the temperature and soot volume fraction. Numerical calculations were conducted using the C-2 chemistry model [Appel-Bockhorn-Frenklach (ABF), Appel, J.; Bockhorn, H.; Frenklach, M. Kinetic modeling of soot formation with detailed chemistry and physics: Laminar premixed flames of C-2 hydrocarbons. Combust. Flame 2000, 121 (1-2), 122-136, DOI: 10.1016/S0010-2180(99)00135-2] with formation of polycyclic aromatic hydrocarbons (PAHs) up to pyrene and a soot model incorporating the dimerization of two pyrene molecules as the soot inception step and hydrogen abstraction acetylene addition mechanism and PAH condensation as the surface growth processes. Numerical results are in qualitative agreement with the experimental measurements when the oxidizer stream is air. The numerical model predicts the temperature well but overpredicts the soot volume fraction in oxygen-enriched flames in both O-2/N-2 and O-2/CO2 atmospheres. With the increase of the oxygen mole fraction in the oxidizer stream, the flame becomes brighter and shorter, the peak temperature zone shifts from the flame wing to the upper part, and the peak soot volume fraction moves from the flame wing to the flame center. The soot loading grows rapidly with increasing the oxygen mole fraction in the oxidizer stream. Under the same oxygen mole fraction, the temperature and soot volume fraction in the O-2/N-2 atmosphere are always higher than those in the O-2/CO2 atmosphere as a result of the higher heat capacity of CO, and soot formation suppression by CO,. The chemical effect of CO, may promote 0 and OH, which enhance the oxidation of the critical soot formation species, including H, C2H2, C6H6, and C16H10. The primary pathway for the chemical effect of CO, is its competition for the H radical to form CO and OH, i.e., CO2 + H reversible arrow CO + OH. Soot formation in these flames is affected by two primary reactions: CO2 + H reversible arrow CO + OH and H + O-2 reversible arrow O + OH.

Numerical and experimental investigations on the particle formation in oxymethylene ethers (OME n , n = 2−4)/ethylene premixed flames

Particle formation in oxymethylene ethers (OMEn, n = 2-4) / ethylene premixed flames

Experimental and numerical study on the effect of oxymethylene ether-3 (OME3) on soot particle formation

Role of Dimethyl Ether in Incipient Soot Formation in Premixed Ethylene Flames

Numerical Study of Novel OME 1−6 Combustion Mechanism and Spray Combustion at Changed Ambient Environments

Laminar Burning Velocities, CO, and NOx Emissions of Premixed Polyoxymethylene Dimethyl Ether Flames

Role of CH2O Moiety on Laminar Burning Velocities of Oxymethylene Ethers (omen): A Case Study of Dimethyl Ether, OME1 and OME2

In-situ Laser Diagnostic and Numerical Investigations of Soot Formation Characteristics in Ethylene and Acetylene Counterflow Diffusion Flames Blended with Dimethyl Carbonate and Methyl Formate

Oxymethylene ether-<i>n</i> -dodecane blend spray combustion: Experimental study and large-eddy simulations

Speciation and the Laminar Burning Velocities of Poly(oxymethylene) Dimethyl Ether 3 (POMDME3) Flames: an Experimental and Modeling Study

Soot Particles Formed by N-Heptane and N-Heptane/oxymethylene Ether-3 in an Inverse Diffusion Flame: A Comparative Analysis of Chemical Features

Soot and Flame Structures in Turbulent Partially Premixed Jet Flames of Pre-Evaporated Diesel Surrogates with Admixture of OMEn

LES and RANS Spray Combustion Analysis of OME3-5 and n-Dodecane

Cross-effect considered skeletal chemical mechanism construction for primary reference fuel/oxymethylene ethers blends using radical trace and sensitivity analysis

Numerical study on the temperature dependence of soot formation in acetylene pyrolysis blended with methane, formaldehyde, methanol, and dimethyl ether

An optical investigation of Fischer-Tropsch diesel and Oxymethylene dimethyl ether impact on combustion process for CI engines

Experimental And Numerical Investigations Of Soot Formation In Laminar Coflow Ethylene Flames Burning In O-2/N-2 And O-2/Co2 Atmospheres At Different O-2 Mole Fractions

Effects of 1-Pentanol, Methyl Butyrate and Polyoxymethylene Dimethyl Ether on Soot Formation in Isooctane Inverse Diffusion Flames

Auto-ignition of Oxymethylene Ethers (omen, N = 2–4) As Promising Synthetic E-Fuels from Renewable Electricity: Shock Tube Experiments and Automatic Mechanism Generation

Experimental and Kinetic Modeling Study of Premixed O-Xylene Flames

Insight into Premixed Diethoxymethane Flames: Laminar Burning Velocities, Temperatures, and Emissions Behaviour