Synthesis and Characterization of PS/PVP Polymer Blend Composites with Different Nanofillers for Production of Green Hydrogen

Vaishali Suthar,Harsh D. Patel,Anwesh Patel,Naveen K. Acharya,C. N. Murthy

DOI: https://doi.org/10.1007/s11664-024-11563-2

IF: 2.1

2024-11-10

Journal of Electronic Materials

Abstract:This paper reports a study of composite blends of polysulfone (PS) and polyvinylpyrrolidone (PVP) that were prepared in different wt% composition using carbon nanotubes (CNT), milled carbon fibers (MCF), graphene oxide (GO), and chopped carbon fibers (CCF) as nanofillers. The permeability measurements of the composites showed that the PS/PVP blends with different nanofillers demonstrated higher permeability for hydrogen gas than that of the pristine polymers, either singly or the polymer blend. The gases used for the permeation measurements were H 2 , CO 2 , N 2 , O 2 , and CH 4 . Selectivity was calculated for H 2 /CO 2 , H 2 /N 2 , and H 2 /CH 4 gas pairs. The results of the selectivity were plotted to show Robeson's 2008 upper bound and compared with reported data. The permeability of all gases increased for modified composite polymer membranes. We noted that O 2 gas solubility follows a trend similar to other gases, but gives a higher value than H 2 gas. The selectivity measurements showed that the MCF and CCF composite with the PS/PVP blend membranes demonstrated the highest selectivity for hydrogen gas among all different gas pairs. This indicates that PS/PVP composite membranes with MCF and CCF can be used for hydrogen purification and production of green hydrogen. There is a trade-off between permeability and selectivity parameters; GO and CNT nanofillers showed constant selectivity as permeability increased, which can be explained by the nanogap theory. The structural and morphological properties of these prepared composite membranes were characterized by field-emission scanning electron microscopy (FE-SEM), thermal properties by differential scanning calorimetry (DSC), and mechanical properties using a universal testing machine (UTM) for tensile strength, and Fourier transform infrared (FTIR) spectroscopy was carried out to identify the possible bond between polymers and nanofillers of the blend composite membranes. Blends modified with CNT, MCF, and GO exhibited increased viscosity, with an increase in the ∆b value at increasing concentrations, suggesting a favorable interaction between the phases. The water flux studies indicated that the highest pure water flux was obtained by the PS + PVP + CCF membrane. The highest rejection of Na 2 SO 4 and of MgSO 4 was for the PS + PVP + CNT membrane.

engineering, electrical & electronic,materials science, multidisciplinary,physics, applied