Abstract:In this study, the process of carbon dioxide (CO2) capture directly from ambient air in a conventional monoethanolamine (MEA) absorption process was simulated and optimized using a rate-based model in Aspen Plus. The process aimed to capture a specific amount (148.25 Nm3/h) of CO2 from the air, which was determined by a potential application aiming to produce synthetic methane from the output of a 2.7 MW electrolyser (593 Nm3/h H2). We investigated the technical performance of the process by conducting a sensitivity analysis around different parameters such as air humidity, capture rate defined as a ratio of moles of CO2 captured during the process to the total mole of CO2 in the feed stream, CO2 loading of lean and rich absorption liquids and reboiler temperature, and evaluated the energy consumption and overall cost in this system. In order to meet the design requirement for standard packed columns, the rich absorption liquid was circulated to the top of the absorber. A capture rate of 50% was selected in this process as a baseline. At higher capture rates, the required energy per ton of captured CO2 increases due to a higher steam stripping rate, required in the desorber, and at lower capture rates, the size of equipment, in particular, absorber and blowers increases due to the need for processing a significantly larger volume of air at the given CO2 production volume. At the base case scenario, a reboiler duty of 10.7 GJ/tCO2 and an electrical energy requirement of 1.4 MWh/tCO2 were obtained. The absorber diameter and height obtained were 10.4 and 4.4 m, respectively. The desorber is found to be relatively small at 0.54 m in diameter and 3.0 m in height. A wash water section installed at top of the absorber decreased the MEA loss to 0.28 kg/ton CO2. However, this increased capital cost by around 60% resulting in CO2 capture costs of $1,691 per ton CO2 for the MEA base scenario. Based on the techno-economic analysis, assuming a non-volatile absorbent rather than MEA thereby avoiding a wash water section, and using an absorption column built from cheaper materials, the estimated cost per ton of CO2 produced was reduced to $676/tCO2. The overall cost range was between $273 and $1,227 per ton of CO2 depending on different economic parameters such as electricity ($20–$200/MWh) and heat price ($2–$20/GJ), plant life (15–25 years) and capital expenditure (±30%). In order to reduce the cost further, the use of innovative cheap gas-liquid contactors that operate at lower liquid to gas ratios is crucial.

Techno-economic analysis of carbon molecular sieve membranes to produce oxygen enrichment air

Techno-Economic Optimization of Multistage Membrane Processes with Innovative Hollow Fiber Modules for the Production of High-Purity CO2 and CH4 from Different Sources

Experimental and Modeling Study of the O-2-Enrichment by Perovskite Fibers

A High-Permeance Supported Carbon Molecular Sieve Membrane Fabricated by Plasma-Enhanced Chemical Vapor Deposition Followed by Carbonization for Co2 Capture

Techno-Economic Analysis of Ethylene Adsorptive Separation Using Zeolite 13X in Oxidative Coupling of Methane Integrated Process

Carbon Dioxide Electroreduction to Multi-Carbon Products Using a Large-Scale Membrane Electrode Assembly

Anion-Exchange Membrane Oxygen Separator

Techno-Economic Analysis of a Carbon Molecular Sieve-Based Xylene Isomer Purification Process

Membrane processes for CO2 removal and fuel utilization enhancement for solid oxide fuel cells

Mixed Oxygen Ionic and Electronic Conducting Membrane Reactors for Pure Chemicals Production

Production and application of O2 enriched air produced by fresh and salt water desorption in chemical plants

Integration of an O2 Transport Membrane and a Biomass-Fueled SCO2 Cycle for Liquid CO2/freshwater/power Production: ANN-based Optimization and Techno-Economic Evaluation

Research Progress and Materials Selection Guidelines on Mixed Conducting Perovskite-Type Ceramic Membranes for Oxygen Production

Process Operability Analysis of Membrane-Based Direct Air Capture for Low-Purity CO2 Production

Techno-Economic Assessment for CO2 Capture From Air Using a Conventional Liquid-Based Absorption Process

Oxygen-enriched Carbon Molecular Sieve Hollow Fiber Membrane for Efficient CO2 Removal from Natural Gas

Techno-economic analysis of chemical looping air separation using a perovskite oxide sorbent

Analysis of the Techno-Economic Competitiveness of a Three-Stage Membrane Separation Process for Biogas Upgrading Using a Biopolymer-Based Mixed-Matrix Membrane

Techno-Economic Analysis of Electrochemical Refineries Using Solid Oxide Cells for Oxidative Coupling of Methane

An Energy–Economic–Environment Tri-Objective Evaluation Method for Gas Membrane Separation Processes of H2/CO2

Partial oxidation of ethane to syngas in an oxygen-permeable membrane reactor