Ramped Vane Control of a Compression Corner-Induced Flow Separation

T. Nilavarasan,Ganapati N. Joshi

DOI: https://doi.org/10.1007/s42405-023-00700-6

IF: 1.233

2024-01-26

International Journal of Aeronautical and Space Sciences

Abstract:A numerical study was conducted to determine the ability of 'Ramped Vane (RV)' type vortex generators in mitigating the shock-induced flow separation formed in the vicinity of a planar compression corner. The incoming freestream flow was at Mach 2 and the ramp angle was 24°. The RVs were placed 50 mm upstream of the corner, where the local boundary layer thickness (δ RV ) was 3.5 mm. The devices were completely submerged within the boundary layer and were 2 mm ( h = 0.57δ RV ) and 2.5 mm ( h = 0.71δ RV ) tall. Strong streamwise counter-rotating vortices were produced by the RVs, which replaced the low-momentum fluid in the near-wall region with high-momentum fluid from the outer parts of the boundary layer. As a result, the boundary layer was able to push through the adverse pressure gradient to a greater extent, delaying the onset of flow separation. The larger RVs exhibited superior separation control performance, as the vortices originating from these devices lifted off at a relatively rapid pace and thus were able to remove the low momentum fluid more quickly from the near-wall region. Additionally, the surface flow patterns showed conspicuous spade-shaped patterns ahead of the compression corner, which are likely the footprints of tornado-like vortices formed due to the interaction between the streamwise vortices and the main separation bubble. The paper also presents a detailed analysis of these topological alterations using the critical point theory.

engineering, aerospace