Abstract:Control of competing parameters such as thermoelectric (TE) power and electrical and thermal conductivities is essential for the high performance of thermoelectric materials. Bulk-nanocomposite materials have shown a promising improvement in the TE performance due to poor thermal conductivity and charge carrier filtering by interfaces and grain boundaries. Consequently, it has become pressingly important to understand the formation mechanisms, stability of interfaces and grain boundaries along with subsequent effects on the physical properties. We report here the effects of the thermodynamic environment during spark plasma sintering (SPS) on the TE performance of bulk-nanocomposites of chemically synthesized Bi(2)Te(2.7)Se(0.3) nanoplatelets. Four pellets of nanoplatelets powder synthesized in the same batch have been made by SPS at different temperatures of 230, 250, 280, and 350 °C. The X-ray diffraction, transmission electron microscopy, thermoelectric, and thermal transport measurements illustrate that the pellet sintered at 250 °C shows a minimum grain growth and an optimal number of interfaces for efficient TE figure of merit, ZT∼0.55. For the high temperature (350 °C) pelletized nanoplatelet composites, the concurrent rise in electrical and thermal conductivities with a deleterious decrease in thermoelectric power have been observed, which results because of the grain growth and rearrangements of the interfaces and grain boundaries. Cross section electron microscopy investigations indeed show significant grain growth. Our study highlights an optimized temperature range for the pelletization of the nanoplatelet composites for TE applications. The results provide a subtle understanding of the grain growth mechanism and the filtering of low energy electrons and phonons with thermoelectric interfaces.

Thermal design for enhanced temperature uniformity on spark plasma sintering device

Localized Overheating Phenomena and Optimization of Spark-Plasma Sintering Tooling Design

Heat sink design for thermoelectric generation in spindle unit

Novel Experimental Strategy Towards Temperature Inhomogeneity During Spark Plasma Sintering of Metallic Glasses

Effect of spark plasma sintering temperature on thermoelectric properties of Bi 2 S 3 polycrystal

Understanding Anisotropy and Its Relations with Sintering Conditions on Thermoelectric Transport Properties of n-Type Mg 3 Sb 2 -Based Materials

Using the Spark Plasma Sintering System for Fabrication of Advanced Semiconductor Materials

Heat Exchanger Design for A Thermoelectric Module to Drive Wireless Sensors in Spindle Monitoring

Interface driven energy filtering of thermoelectric power in spark plasma sintered Bi(2)Te(2.7)Se(0.3) nanoplatelet composites.

Maximizing Thermoelectric Performance of AgPbmSbTem+2 by Optimizing Spark Plasma Sintering Temperature

Thermal design of operating parameter for reliable AlSi7Mg selective laser melting

A new approach of preheating and powder sintering in electron beam powder bed fusion

Efficient Thermal Management Strategies for 3D-SiP Architectures

Optimization of process parameters for the development of Ni–Al-Ti-Mn-Co-Fe–Cr high entropy alloy system via spark plasma sintering

Development of Spark Plasma Syntering (SPS) technology for preparation of nanocrystalline p-type thermoelctrics based on (BiSb)2Te3

Transparent Al2O3 fabricated by energy efficient spark plasma sintering

Towards Enhanced Sintering Resistance: Air-plasma-sprayed Thermal Barrier Coating System with Porosity Gradient

Optimizing heat source distribution in sintering molds: Integrating response surface model with sequential quadratic programming

Improvement of mid‐temperature ZT in a Bi-Se-Te via a two two-step sintering process

An efficient plate heater with uniform surface temperature engineered with effective thermal materials

Fabrication and Characterization of Thermoelectric CrSi2 Compound by Mechanical Alloying and Spark Plasma Sintering