Abstract:The paper is concerned about a measuring method developed by the present author based on FTIR for measuring the concentrations of components in the toxic gases harmful both to human health and the environment quality.The said experimental system was established based on the use of Fourier transform infrared spectrometer, gas compounding equipment,vacuum pump as well as other devices. To make the quantitative analysis successful,we have chosen eight kinds of classic toxic gases with low concentration,including CO, CO_2,NO,NO_2,SO_2,HCl,HBr and HCN.The best calculated spectrum regions of the 8 components were analyzed in hoping to avoid the interference of vapor and carbon dioxide from the outside environment as the result of a series of trials and appropriate choice. The sample of calibration set has been tested and verified by the method of Mahalanobis distance (M) for the model to be soundly established. For example,we have deleted two samples due to their being less purposeful for our research goals.Then,two data matrixes were adopted to establish our model,one of which is infrared spectrum data matrix and the other of which is the gas concentration data matrix.And,finally,the partial least square (PLS) regression model was established after choice of an appropriate spectrum region,data pre-treating,standards selection and parameters setting.With the result of each component verified by the P1.S model and regulated by the multinomial,the fitting regression coefficient between the actual concentrations and predicted concentrations of each component proved to be higher than 0.99,and the Root-mean Standard F.rror of Calibration (S_(RMSEC)) proves lower than 15 × 10~(-6).With the expected performance of the model well verified by the standards in validation set,the error of the concentration prediction proves lower than ±2% FS and the Root-mean Standard Error of Prediction (S_(RMSEP)) is lower than 20 × 10~(-6).Thus,it can be seen that the proposed qualitative analysis of such toxic gases based on FTIR is a new valuable method for gas detection,which can be applied for environmental monitoring, chemical plants' quality-inspection,fire-hazards detection,anti-terrorist activities and other areas concerned.

Quantitative detection of multicomponent SF 6 decomposition products based on Fourier transform infrared spectroscopy combined with SCARS-DNN

Effects of SF 6 decomposition components and concentrations on the discharge faults and insulation defects in GIS equipment.

Effects of SF6 decomposition components and concentrations on the discharge faults and insulation defects in GIS equipment

Ultratrace CO/SF 6 Detection System Based on Differential Fourier Transform Infrared Spectroscopy Combined with the Weighted Sine Spectral Reconstruction Convolutional Neural Network (WSSR-CNN) Model

Analysis of Decomposition By-Products and Its Formation Mechanism of SF6/N2 Mixed Gases under Spark Discharge

Near-infrared spectroscopy soft-sensing method by combining partial least squares discriminant analysis and support vector machine

Type Identification of GIS Partial Discharge Based on SF<inf>6</inf> Decomposition Characteristics under Negative DC Voltage

Detection of SF 6 Decomposition Components under Partial Discharge by Photoacoustic Spectrometry and Its Temperature Characteristic

A ppb-level online detection system for gas concentrations in CS 2 /SO 2 mixtures based on UV-DOAS combined with VMD-CNN-TL model

Application of a Partial Discharge Diagnosis Method Based on the Novel Multispectral Array Sensor and GMM in Different Insulating Gases

Development and Application of Multi-Component Dynamic Gas Distribution Instrument Based on Mass Flow Controller

Study on the Quantitative Analysis of Multi-Component Toxic Gases Based on FTIR

Ni-CNT Chemical Sensor for SF6 Decomposition Components Detection: A Combined Experimental and Theoretical Study

Monitoring SF6 Gas Leakage Based on a Customized Binocular System

Highly sensitive photoacoustic multicomponent gas sensor for SF6 decomposition online monitoring

Multi-Gas Analyzer Based on Tunable Filter Non-Dispersive Infrared Sensor: Application to the Monitoring of Eco-Friendly Gas Insulated Switchgears

Decomposition Characteristics of SF6under Three Typical Defects and the Diagnostic Application of Triangle Method

Gas Insulated Switchgear Partial Discharge Type Identification Based on Frequency Division Features and Improved Long Short-Term Memory Neural Networks

Study on Ultraviolet Absorption Characteristics of SF6 Decomposition Components

Chemical Kinetic Model Of Sf6/O-2/H2o Decomposition Products Under 50 Hz Ac Corona Discharges

Identification of Industrial Gas by Sparse Infrared Absorption Spectrum Characteristics and Support Vector Machine