Abstract:The unique characteristics of gas-solids two-phase flow and fluidization in terms of the flow structures and the apparent behavior of particles and fluid-particle interactions are closely linked to physical properties of the particles, operating conditions and bed configurations. Fluidized beds behave quite differently when solid properties, gas velocities or vessel geometries are varied. An understanding of hydrodynamic changes and how they, in turn, influence the transfer and reaction characteristics of chemical and thermal operations by variations in gas-solid contact, residence time, solid circulation and mixing and gas distribution is very important for the proper design and scale-up of fluidized bed reactors. In this paper, rather than attempting a comprehensive survey, we concentrate on examining some important positive and negative impacts of particle sizes, bubbles, clusters and column walls on the physical and chemical aspects of chemical reactor performance from the engineering application point of view with the aim of forming an adequate concept for guiding the design of multiphase fluidized bed chemical reactors. One unique phenomenon associated with particle size is that fluidized bed behavior does not always vary monotonically with changing the average particle size. Different behaviors of particles with difference sizes can be well understood by analyzing the relationship between particle size and various forces. For both fine and coarse particles, too narrow a distribution is generally not favorable for smooth fluidization. A too wide size distribution, on the other hand, may lead to particle segregation and high particle elutriation. Good fluidization performance can be established with a proper size distribution in which inter-particle cohesive forces are reduced by the lubricating effect of fine particles on coarse particles for Type A, B and D particles or by the spacing effect of coarse particles or aggregates for Type C powders. Much emphasis has been paid to the negative impacts of bubbles, such as gas bypassing through bubbles, poor bubble-to-dense phase heat & mass transfer, bubble-induced large pressure fluctuations, process instabilities, catalyst attrition and equipment erosion, and high entrainment of particles induced by erupting bubbles at the bed surface. However, it should be noted that bubble motion and gas circulation through bubbles, together with the motion of particles in bubble wakes and clouds, contribute to good gas and solids mixing. The formation of clusters can be attributed to the movement of trailing particles into the low-pressure wake region of leading particles or clusters. On one hand, the existence of down-flowing clusters induces strong solid back-mixing and non-uniform radial distributions of particle velocities and holdups, which is undesirable for chemical reactions. On the other hand, the formation of clusters creates high solids holdups in the riser by inducing internal solids circulations, which are usually beneficial for increasing concentrations of solid catalysts or solid reactants. Wall effects have widely been blamed for complicating the scale-up and design of fluidized-bed reactors. The decrease in wall friction with increasing the column diameter can significantly change the flow patterns and other important characteristics even under identical operating conditions with the same gas and particles. However, internals, which can be considered as a special wall, have been used to improve the fluidized bed reactor performance. Generally, desirable and undesirable dual characteristics of interaction between particles and fluid are one of the important natures of multiphase flow. It is shown that there exists a critical balance between those positive and negative impacts. Good fluidization quality can always be achieved with a proper choice of right combinations of particle size and size distribution, bubble size and wall design to alleviate the negative impacts.

Insight into the effect of particle density and size on the hydrodynamics of a particular slurry bubble column reactor by CFD-PBM approach

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Influence of Slurry Velocity and Concentration Distributions on Fischer-Tropsch Synthesis in Slurry Bubble Column Reactor

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Effect of hydrodynamic heterogeneity on particle dispersion in a Taylor-Couette flow reactor with variable configurations of inner cylinder

Numerical Simulations Of Fluid Dynamics And Mixing In A Large Shallow Bubble Column: Effects Of The Sparging Pipe Allocations For Multiple-Pipe Gas Distributors

Mixing characteristics of fixed bed bubble reactor

Numerical simulations of particle concentration and size effects in a slurry bubble column with a CFD‐PBM coupled model

Effect of Particles on Hydrodynamics and Mass Transfer in a Slurry Bubble Column: Correlation of Experimental Data

Rising and descending bubble size distributions in gas–liquid and gas–liquid–solid slurry bubble column reactor

Bubble Dynamics and Particle Orientation in a Binary Fluidized Bed Containing Spherocylinders and Spheres

Effects of particle size on bubble dynamic behaviors in a quasi-two-dimensional gas-solid fluidized bed

Hydrodynamic performance and structural optimization of a slurry bubble column with vertical tube internals

Impact of the Reactor Structure on Biomass Pyrolysis in Fluidized-Bed Reactors: A Coarse-Grained CFD-DEM Study

Experimental Study on Bubble Behavior and CFD Simulation of Large-Scale Slurry Bubble Column Reactor

Multi-scale simulation of particle density effects on hydrodynamics in dense gas-solid fluidized beds

Influences of fluid physical properties, solid particles, and operating conditions on the hydrodynamics in slurry reactors

CFD-PBM Approach with Different Inlet Locations for the Gas-Liquid Flow in a Laboratory-Scale Bubble Column with Activated Sludge/Water.

Numerical Investigation of Flow, Heat Transfer, and Kinetic Reaction in a Large‐difference Bidisperse, Circulating Fluidized‐bed Reactor

Dual Characters of Interaction Between Particles and Fluid