Abstract:Cellulose nanocrystal and chitosan blended Nanocomposite for dye removal. Development of a cost‐effective and environmentally friendly method to treat dye wastewater is of utmost importance. In this experimental study, wastepaper was used as the raw material for the extraction of cellulose nanocrystals to fabricate a nanocomposite membrane with chitosan. During the extraction process, acid hydrolysis (Sulfuric acid) followed by bleaching (hydrogen peroxide) was adopted. To confirm the nano‐range, particle size analysis, and FESEM were performed, which confirmed the presence of particles in the nano‐range ranging from 313.8 to 122.1 nm and FESEM observed results showed transformation of fibrous to rod shaped nanocrystals after acid hydrolysis. After successful nanocomposite fabrication a porous sieved network of membrane was observed and after adsorption successful adhesion of dye molecules over the membrane matrix was also confirmed. FTIR data showed that during adsorption mechanism some of the prominent peaks gets disappeared suggest interaction of dye molecules onto the nanocomposite. The contact angle of 21.0° was observed for the ChNC3 nanocomposite showed super hydrophilic behavior. Tensile strength was also observed in terms of young's modulus, ultimate strength, and elongation at break. The elasticity and stiffness of a material are usually indicated by its young modulus. In AH CNCs and ChNC3, the young modulus was seen to be increasing from 195 0.316, respectively. Furthermore, the potentiality of the nanocomposite membrane was analyzed for Congo red dye in synthetic wastewater prepared in the laboratory. During the batch study, various working parameters were taken such as initial dye solution (20–100 ppm), pH (1–7), contact time (10–60 min), and dosage (0.1–0.5 mg/L). To know about adsorption, Langmuir and Freundlich isotherm were analyzed it was observed that Freundlich isotherm show best fitted modeling with R2 = 0.99, and n = 1.6 showing favorability of the heterogeneous adsorption. To determine the interaction between the adsorbate and adsorbent, pseudo first order and pseudo second order kinetics models were analyzed, and it was observed that chemisorption interaction followed between the adsorbate and adsorbent. Thermodynamic parameters were analyzed, which confirmed the spontaneous and favorable adsorption mechanism. To avoid fouling problems and maintain cost effectiveness, the resulting, nanocomposite membrane was desorbed using an appropriate solvent. After 5 cycles, the desorption rate decreased from 54% to 38%. This developed nanocomposite membrane appears to be effective in effluent waste treatment because of its simple formulation approach.

Dye adsorption and antimicrobial performances of composite nanofiber membranes containing cuprammonium cellulose

Preparation and Performance of Quaternary Ammonium Salt-Containing Methacrylate Copolymer-Based Ultrafiltration Membranes

Novel wastepaper nanocellulose/chitosan‐based nanocomposite membrane for effective removal of the textile dye Congo red from aqueous solution

Interfacially Crosslinked Composite Porous Membranes for Ultrafast Removal of Anionic Dyes from Water Through Permeating Adsorption.

Low-pressure thin-film composite nanofiltration membranes with enhanced selectivity and antifouling property for effective dye/salt separation

Self-supporting and hierarchical porous membrane of bacterial nanocellulose@metal-organic framework for ultra-high adsorption of Congo red

Multifunctional Bacterial Cellulose/Covalent Organic Framework Composite Membranes with Antifouling and Antibacterial Properties for Dye Separation

High performance loose-structured membrane enabled by rapid co-deposition of dopamine and polyamide-amine for dye separation

Composite membranes with multifunctionalities for processing textile wastewater: Simultaneous oil/water separation and dye adsorption/degradation

Design and function of lignin/silk fibroin-based multilayer water purification membranes for dye adsorption

Electrospinning of Sodium Alginate/Copper Oxide Nanofibrous Composite Membrane and Its Application of Cationic Dye Adsorption

Removal of Methylene Blue and Congo Red Using a Chitosan-Graphene Oxide-Electrosprayed Functionalized Polymeric Nanofiber Membrane

Dye adsorption properties of poly(p-phenylene terephthalamide)-embedded hollow fiber composite membranes

Application of electrospun N-doped carbon dots loaded cellulose acetate membranes as cationic dyes adsorbent

Exploring the sustainable elimination of dye using cellulose nanofibrils- vinyl resin based nanofiltration membranes

Development of Elaeis guineensis/polyvinyl alcohol/carbon nanotube composites for efficient adsorption of dye: Experimental and theoretical approach

Synthesis of cellulose cotton-based UiO-66 MOFs for the removal of rhodamine B and Pb(II) metal ions from contaminated wastewater

Preparation and characterization of a bi-layered nano-filtration membrane from a chitosan hydrogel and bacterial cellulose nanofiber for dye removal

Efficient removal of anionic, cationic textile dyes and salt mixture using a novel CS/MIL-100 (Fe) based nanofiltration membrane

Multifunctional bacterial cellulose-bentonite@polyethylenimine composite membranes for enhanced water treatment: Sustainable dyes and metal ions adsorption and antibacterial properties

Fabrication and characterization of electrospun polyacrylonitrile (PAN) @ bamboo shoot cellulose nanowhisker (BSCNs) @ carbon nanotube (CNT) composite membrane with enhanced dye adsorption properties