Abstract:The requirements for the use of lightweight structures, damage-resistant materials, and optimal fuel consumption in various industries such as aerospace, marine, and automotive structures have increased the need for designing new structural systems to meet these demands. According to research, Fiber Metal Laminates (FMLs) are excellent candidates to meet the above needs. In this study, the tensile test specimens were fabricated according to ASTM D 3039 standard from plain textured glass fibers, aluminum sheet Al 6061-T6 with a thickness of 0.5 mm, and epoxy resin with lay-up of [AL/(GFRP [0,90]4)/Al/(GFRP [0,90]4)/Al]. Glass Fiber Reinforced Plastic (GFRP) specimens were also constructed using E-GLASS fibers with [0,90]20 lay-up. GLARE and GFRP specimens were subjected to tensile testing in two types of simple and open-hole at ambient temperature at the loading rate of 2 mm/min. Failure modes of the simple specimens were studied with open-hole specimens. The failure mechanism in simple glass laminate aluminum reinforced epoxy (GLARE) was delamination, however, in open-hole GLARE, no delamination occurred except for some areas around the hole, and the specimen was broken in the hole area. Open-hole GFRP‌ specimens were all broken in the hole area and simple specimens mainly in several regions in the gauge length range. Scanning Electron Microscopy (SEM) images recorded from the hole area of GLARE‌ specimens clearly show that local debonding in the area around the hole caused the breakage of the specimen. In addition, the ratio of the ultimate stress of the simple GFRP‌ specimen to the open-hole specimen is 1.18 and the same ratio is 1.07 for GLARE‌ specimens. This indicates less hole effect on the ultimate stress in GLARE specimens than in GFRP. Furthermore, curved fibers around the hole can be used to reduce damage due to fracture and delay in its occurrence.

Effect Of A Linear Parameter On The Brittle Fracture Of An Elastic Layer With A Circular Hole

Brittle Fracture of an Elastic Layer with a Defect in the Form of a Circle under Biaxial Loading

Failure assessment of eccentric circular holes under compressive loading

Study the effect of circular hole on dynamic fracture properties of cracked PMMA specimen under impact loads

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

A Theoretical Analysis for the Normal Impact Fracture in Thin Brittle Plates Based on the Principle of Minimum External Work

Hyperelastic effects in brittle materials failure

Comparison of the phase-field approach and cohesive element modeling to analyze the double cleavage drilled compression fracture test of an elastoplastic material

Hyperelasticity Governs Dynamic Fracture at A Critical Length Scale

Fractographic Mirror Law for Brittle Fracture of Nonlinear Elastic Soft Materials

Brittle fracture in a periodic structure with internal potential energy. Quasi-static analysis

Effects of porosity on the measured fracture energy of brittle materials

Failure Criteria for Brittle Notched Specimens

On the effects of material strength in dynamic fracture: A phase-field study

Constraint evaluation and effects on selected fracture parameters for single-edge notched beam under four-point bending

Effect of Strain Rate Sensitivity on Fracture of Laminated Rings under Dynamic Compressive Loading

Experimental study for the effect of hole notched in fracture mechanics of GLARE and GFRP composites subjected to quasi-static loading

Application of a Closed-Form Model in Analyzing the Fracture of Quasi-Brittle Materials

Mode I and II Interlaminar Fracture in Laminated Composites: A Size Effect Study

Bilinear Softening Model and Double K Fracture Criterion for Quasi-Brittle Fracture of Pultruded FRP Composites

Fracture mechanical behavior of polymers: 1. Amorphous glassy state