Abstract:In the last few years, broadband and switchable frequency selective surfaces (FSSs) absorber/reflector are of great importance in different areas such as stealth system, EM interference, EM compatibility, and so on. In this paper, to obtain a switchable frequency selective surfaces absorber/reflector in different states, a broadband and switchable absorber using an absorb/reflective FSS is presented. The top layer of the proposed switchable absorber is a periodic arrangement of square loops loaded with PIN diodes on a dielectric substrate which has a sufficient mechanical strength to hold up all the units, and under the square loops there are honeycomb of a certain thickness and a thin layer of metal. The structure has been characterized with the full-wave analysis and shows good absorption/reflection switching performance. Intrinsic impedance of proposed structure has also been investigated to explain the switching and the broadband absorption mechanisms of the structure. The working frequency band of the switchable absorbing structure is 2.5 ~ 5.5 GHz, and it switches states by changing the bias voltage. Biasing at different voltages to turn ON and OFF the diodes, the FSS structure can switch freely between absorption and reflection state. In ON state, the switchable FSS has two states working as a wideband absorber and the reflectivity in 2.5 ~ 5.5 GHz is below -10 dB, while in OFF state it has fine reflective property. In addition, inductances are used to connect each element of the structure to achieve the purpose of broadband isolation. Simulation and measurement results demonstrate the performance of the proposed structure.

SPICE‐based modeling of a polarization‐independent active frequency selective surface based tunable absorber with high angular stability

Broadband Tunability of Polarization-Insensitive Absorber Based on Frequency Selective Surface

Graphene-FSS Hybrid Absorptive Structure with Amplitude/Frequency Dual-Modulated Passband

A Novel Tunable Frequency Selective Surface Absorber with Dual-Dof for Broadband Applications.

Tunable Composite Absorber with Active Frequency Selective Surface

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

A Tuneable Microwave Absorber Using AFSS

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

Device Modeling of RF Varactor Diodes for Adjustable Microwave Reflectivity in Active Frequency Selective Surfaces

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

A Frequency-Selective Surface Rasorber Based on Four Functional Layers

Circuit Model Analysis of Switchable Perfect Absorption/Reflection in an Active Frequency Selective Surface.

A Thin and Broadband Tunable Radar Absorber Using Active Frequency Selective Surface

AN ANGULAR STABILIZED FREQUENCY SELECTIVE SURFACE BY USING CAPACITANCE LAYERS STRUCTURE

Active Frequency Selective Surface Absorber With Point-to-Point Biasing Control System

Four-Mode Switchable Frequency-Selective Surface Featuring Wide-Band and Angular Stability

Thin and Broadband Electromagnetic Absorber Design Using Resistors and Capacitors Loaded Frequency Selective Surface

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Multistate Active Control RCS Signature for the Continuous Adjustment Absorber/reflector Transformation Applications.

Optimize the dielectric slab of the tunable active frequency selective surface absorbing material

Design of a Tunable Low-Frequency and Broadband Radar Absorber Based on Active Frequency Selective Surface