Abstract:The optical fiber composite ground wire (OPGW), serving as a ground wire and providing communication capabilities, has been widely utilized in high-voltage transmission lines in China. Considering the fault current diversion during short circuits and lightning events, OPGW is generally grounded at each tower, while in case of which the induced electromotive force on OPGW generated by the alternating current forms an induced current loop and causes energy losses in the grounding loop. The issue becomes more prominent in higher voltage levels and larger load currents. The assessment of losses before insulating OPGW is crucial data to support the economic consideration and power saving expectation for OPGW insulation retrofit of the overhead power line. To provide a valuable reference and reveal the need for insulation retrofits of the OPGW, this study investigates the induced currents along each tower-grounded OPGW and the corresponding induced power losses on the 750kV double-circuit transmission lines. The impact of various line parameters and operational conditions are discussed via the numerical simulation. The results indicate that the total losses can reach 10 6 kWh/a.km when both circuits are transmitting power at a full load of 2300 MVA. The tower span, tower grounding resistance, and the DC resistance of the OPGW are found to have minimal impact on the total power losses, although the current distribution is affected by these factors. Conductor transposition, phase sequences, and transmission load current have a significant influence on both the amplitude of the induced current and the power losses. Reverse phase sequence ABC-CBA and the symmetrical load on both sides of the circuits could obtain the lowest induced power loss.

Research and Application of a New Modular Insulated OPGW Splicing Device in Improving the Quality and Efficiency of Transmission Line Operation and Maintenance

Glass-based integrated optical splitters: Engineering oriented research

Design of an Online Monitoring System for Urban Power Optical Cables Based on Distributed Fiber Optic Sensing

Research on Optical Fiber Composite Overhead Wire (OPGW) Lightning Monitoring Technology Based on Weak Fiber Bragg Grating Array

Fabrication and Characterization Glass-Based Integrated Optical Power Splitter

Characteristic of Power-transmission-induced Current and Power Loss on the OPGW of 750 kV Transmission Line System

Health monitoring of electric power communication line using a distributed optical fiber sensor

MULTI-MODE INTERFERENCE POWER SPLITTER IN GaAs FOR OPTICAL COMMUNICATION

Design and Fabrication of 1-by-4 MMI Power Splitter for Optical Communication

Engineering-oriented research of glass-based planar optical power splitter manufacturing technology

Research on non-contact wet mateable connector for optical communication and power transmission

Anti-icing Performance Evaluation of OPGW Based on BOTDA and OTDR

10Kv Insulated Compact Distribution Line Supported by Composite Spacers in Urban Area

Optical Fiber Line Automatic Protection System and Its Application Analysis

Noise suppression method for OPGW transmission line galloping monitoring by using adjacent FBG sensors

OPGW cable icing status monitoring based on BOTDR

On-line Monitoring of Power Transmission Lines in Smart Grid Based on Distributed Optical Fiber Sensing Technology

Distributed Optical Fiber Detection based on BOTDR for Buffer Layer Defects of High-voltage XLPE Cable with Corrugated Aluminum Sheath

Damage Characteristics of OPGWs under Consecutive Lightning Strikes Based on a Coupled Arc-Thermal-Electric Simulation

An optical fiber composite power cable panoramic state monitoring system for typical scene application

A Fast and Accurate Mapping Method for an OPGW Tower Based on Hybrid Distributed Optical Fiber Sensing