Abstract:The 1500 mm-wide AZ31 magnesium alloy plate is an important material for the molding of large shell components. In the industrial rolling process, the wider the plate, the more uneven the temperature and stress distribution in the width direction, which leads to poor mechanical properties and an uneven microstructure. The wider the plate, the more uneven the temperature and stress distribution are in the width direction during the industrial rolling process, which results in poor mechanical properties and an uneven microstructure. In this paper, the mechanical properties and microstructure evolution along the width direction during a single-pass rolling process (6–3 mm) of this plate were qualitatively and quantitatively investigated. Additionally, a cellular automaton (CA) model was used to reproduce the grain distribution along the width direction. The result shows that there is a significant difference in the elongation of different parts of the plates along the wide direction, and the elongation of the center part is significantly higher than the edge, which is related to the uneven microstructure distribution. The average grain size from the edge to the center shows a tendency of increase and then decrease, and the degree of grain refinement has increased. The number of twins increased in the edge part, showing a typical mixed grain state with poor unevenness. Further CA shows that the average grain size and percentage of dynamic recrystallization increase and then decrease from the center to the edge. The parts 0–250 mm and 625–700 mm from the edge are fine-grained (average grain size less than 1 μm) and account for about 46 % of the plate. These parts are preferred for the subsequent further processing of rolled plates.

Transverse microstructural evolution and its cellular automata simulation during hot rolling of AZ31 alloy wide-width plate

Transverse mechanical properties and microstructure of 1500 mm wide AZ31 magnesium alloy plate and its evolution during industrial rolling

Recrystallization Behavior and Mechanical Properties of Az31b Alloy During the Hot-Rolling Process

Microstructure Evolution of Ti-6Al-4V with Periodic Thermal Parameters During Axial Closed Die Rolling Process

Effect of variable thickness cross rolling on edge crack and microstructure gradient of AZ31 magnesium alloy

Microstructures of the deforming zone in hot rolling AZ31 sheet

Mechanical Propertes and Isothermal Rolling Process of AZ31 As-Cast Mg Alloy Plate

Deformation Behavior of AZ31 Mg Alloys Sheet During Large Strain Hot Rolling Process: A Study on Microstructure and Texture Evolutions of an Intermediate-Rolled Sheet

Microstructures and Mechanical Properties of Hot Rolled AZ31 Mg Alloy Sheets

Multi-Scale Modeling of Microstructure Evolution during Multi-Pass Hot-Rolling and Cooling Process

Effect of Rolling Speed on Microstructure and Mechanical Properties of AZ31 Mg Alloys Rolled with a Wide Thickness Reduction Range

Rolling of AZ31 Magnesium Alloy Thin Strip

Microstructure simulation of AA2219 alloy in hot/warm forming and heat treatment using cellular automata methods

Modeling and simulation on dynamic recrystallization of 30Cr2Ni4MoV rotor steel using the cellular automaton method

Evolution of Microstructure, Texture and Mechanical Properties of SiC/AZ31 Nanocomposite During Hot Rolling Process

Simulation and Finite Element Analysis of Continuous Multi-Pass Hot Rolled AZ31B Magnesium Alloy Sheets

Deformation Mechanism and Microstructure Evolution During On-Line Heating Rolling of Az31b Mg Thin Sheets

Simulation of Microstructure and Properties Evolution of Micro Alloyed Steel During Hot Deformation by Cellular Automaton

Modeling and Simulation of Dynamic Recrystallization Behaviors of Magnesium Alloy Az31b Using Cellular Automaton Method

Effect of Rolling and Heat Treatment on Microstructure of Roll-Cast AZ31 Alloy

Effects of Hot Rolling Processing on Microstructures and Mechanical Properties of Mg–3%Al–1%Zn Alloy Sheet