Design of a unique “ON/OFF” switch electrochemical aptasensor driven by the pH for the detection of Aflatoxin B1 in acid solutions based on titanium carbide/ carboxylated graphene oxide- poly(4-vinyl pyridine)/Aptamer composite

Wenjuan Guo,Ahmad Umar,Hassan Algadi,Hasan Albargi,Ahmed A. Ibrahim,Kaili Cui,Luyan Wang,Meishan Pei,Yao Wang

DOI: https://doi.org/10.1016/j.microc.2021.106548

IF: 5.304

2021-10-01

Microchemical Journal

Abstract:<p>A unique ON/OFF switch electrochemical aptasensor was constructed based on the poly (4-vinyl pyridine) (P4VP), titanium carbide (Ti₃C₂Tx), and carboxylated graphene oxide (GO-COOH) composite. The "ON"/"OFF" response of the aptasensor against the pH was caused by the protonation/deprotonation of the pH-sensitive P4VP material depending on the solution pH value above or below 4.9 (pKa of P4VP is 4.9). Thus, it was designed specifically to detect Aflatoxin B1 (AFB1) in acidic environmental. Here, because of its greater specific surface region, Ti₃C₂T_x with high conductivity enhanced the current signal significantly. The electrochemical performance of the aptasensor was optimized when the electrochemical aptasensor was turned to an "ON" state. Results showed that the strongest current signal of the fabricated aptasensor appeared at pH = 4. GO-COOH with a plenty of carboxyl groups was applied as the fixing platform for AFB1 aptamers with amide groups by forming the firm amido-bonds, which was beneficial for the stability of the fixed aptamers. The fabricated aptasensor exhibited a wider linear range of 0.01 to 50 ng mL⁻¹ with a limit of detection of 3 pg mL⁻¹. The wide linear range and low-detection limit of the fabricated aptasensor was due to the exceptional electrochemical efficiency and the ideal synergetic effect of the modifying materials.</p>

chemistry, analytical