Abstract:Recently, an increasing number of studies have progressively explored the radiometric properties of ICE, Cloud, and land Elevation Satellite-2 (ICESat-2), enabling this satellite and its payload to provide support for not only geometric but also radiometric applications. However, due to potential changes in the optical throughput and electronics of the instrument during flight, the essential radiometric corrections are needed for quantitative radiometric applications. In this study, using ICESat-2 signal and noise data on icesheet and desert surfaces, which have a relatively stable reflectance and clear sky, a radiometric correction method is proposed to describe the changes in instrument parameters, i.e., to estimate how much the signal and noise should be exactly scaled. With instrument and environmental parameters provided by the ICESat-2 ATL04/ATL09 product, signal and noise models are used to calculate the theoretical signals and noise levels. The theoretical predictions are then compared with the actual measured signals and noise results by ICESat-2 to obtain the scale factors (or radiometric correction factors) for signal and noise, respectively. The results indicate that all three photon counting electronics (PCEs) (corresponding to three laser pairs) exhibit very close scale factor values (i.e., similar to 1.9), i.e., ICESat-2 receives both signal and noise nearly double the expected values. The noise scale factors F-noise over icesheet are expected to yield the most accurate scale factors because F-noise will change very little with similar to 2.5% (F-signal) and similar to 2.2% ( F-noise) from 2019 to 2022. This study demonstrates the consistency of signal and noise in radiation and also helps to understand the radiation closure and data fusion between the passive background noise and active laser signal for a spaceborne lidar.

The ARCADE 2 Instrument

ARCADE - Atmospheric Research for Climate and Astroparticle DEtection

Design and calibration of a cryogenic blackbody calibrator at centimeter wavelengths

The ARCADE Raman Lidar System for the Cherenkov Telescope Array

Design, Implementation and Testing of the MAP Radiometers

Archeops In-Flight Performance, Data Processing, and Map Making

An Update on Archeops: Flights and Data Products

The ARCADE Raman Lidar and atmospheric simulations for the Cherenkov Telescope Array

Evaluating the Calorimeter Model with Broadband, Continuous Spectra of Starburst Galaxies Observed with the Allen Telescope Array

SARAS CD/EoR Radiometer: Design and performance of the Digital Correlation Spectrometer

Microwave Imaging Radiometers by Aperture Synthesis Performance Simulator (Part 2): Instrument Modeling, Calibration, and Image Reconstruction Algorithms

The Engineering Development Array 2: design, performance and lessons from an SKA-Low prototype station

The Cosmic Background Imager 2

A low noise thermometer readout for ruthenium oxide resistors

Measured Aperture-Array Noise Temperature of the Mark II Phased Array Feed for ASKAP

System design and validation of Central Redundant Array Mega-tile (CRAM)

Instrument Radiometric Correction of Laser Signals and Background Noise for ICESat-2 Photon-Counting Lidar

Year Two Instrument Status Of The Spt-3g Cosmic Microwave Background Receiver

Calibration and Physics with ARA Station 1: A Unique Askaryan Radio Array Detector

Deployment of POLARBEAR-2b

A Balloon-Borne Millimeter-Wave Telescope for Cosmic Microwave Background Anisotropy Measurements