Abstract:A capacitive deionization (CDI) cell was built with electrodes made of an inexpensive commercial activated carbon fiber (ACF), and then modified by incorporating ion-exchangers into the cell compartment. Three modified CDI designs were tested: MCDI – a CDI with electrodes covered by ion-exchange membranes (IEMs) of the same polarity, FCDI – a CDI with electrodes covered by ion-exchange felts (IEFs), and R-MCDI – an MCDI with cell chamber packed with ion-exchange resin (IER) granules. The cell was operated in the batch reactor mode with an initial salt concentration of 1000 mg/L NaCl, a typical level of domestic wastewater. The desalination tests involved investigations of two consecutive operation stages of CDIs: electrical adsorption (at an applied voltage of 1.2 V) and desorption [including short circuit (SC) desorption and discharge (DC) desorption]. The R-MCDI showed the highest electric adsorption as measured in the present study by desalination rate [670 ± 20 mg/(L h)] and salt removal efficiency (90 ± 1%) at 60 min, followed by the MCDI [440 ± 15 mg/(L h) and 60 ± 2%, respectively]. The superior desalination performance of the R-MCDI over other designs was also affirmed by its highest charge efficiency (110 ± 7%) and fastest desorption rates at both the SC [1960 ± 15 mg/(L·h)] and DC [3000 ± 20 mg/(L·h)] modes. The desalination rate and salt removal efficiency of the R-MCDI increased from ∼270 mg/(L h) and 83% to ∼650 mg/(L h) and 98% respectively when the applied voltage increased from 0.6 V to 1.4 V, while decreased slightly when lowering the salt water flow rate that fed into the cell. The packing of IER granules in the R-MCDI provided additional surface area for ions transfer; meanwhile, according to the results of electrochemical impedance spectroscopy (EIS) analysis, it substantially lower down the R-MCDI's ohmic resistance, resulting in improved desalination performance.

Chloride pre-intercalated CoFe-layered double hydroxide as chloride ion capturing electrode for capacitive deionization

Flexible self-supporting CoFe-LDH/MXene film as a chloride ions storage electrode in capacitive deionization

Efficient and Durable Sodium, Chloride‐doped Iron Oxide‐Hydroxide Nanohybrid‐Promoted Capacitive Deionization of Saline Water via Synergetic Pseudocapacitive Process

Docked ions: Vertical-aligned tubular arrays for highly efficient capacitive deionization

Up-shifting the desalination rate limit of capacitive deionization via integrating chloride-capturing Bi nanocluster with flow-through cell architecture

Efficient dual-ions hybrid capacitive system for superior deionization with enhanced kinetics match

Controlled synthesis of bismuth oxychloride-carbon nanofiber hybrid materials as highly efficient electrodes for rocking-chair capacitive deionization

Integrating battery and capacitive materials for efficient sodium and chloride capture

Coupling ion-exchangers with inexpensive activated carbon fiber electrodes to enhance the performance of capacitive deionization cells for domestic wastewater desalination.

Designing NiFe-metal organic frameworks@NiFe-layered double hydroxide/carbon fiber self-supporting electrode for enhanced capacitive deionization

Enhancing the Desalination Performance of Capacitive Deionization Using a Layered Double Hydroxide Coated Activated Carbon Electrode

Faradaic Electrodes Open a New Era for Capacitive Deionization

Facial synthesis of FeOOH array-anchored carbon fiber as flow-through chloride-capturing electrode for ultrafast and super-stable capacitive deionization

Battery Electrode Materials with Omnivalent Cation Storage for Fast and Charge-Efficient Ion Removal of Asymmetric Capacitive Deionization

Tailoring the electrode material and structure of rocking-chair capacitive deionization for high-performance desalination

Strong Interface Coupling Boosting Hierarchical Bismuth Embedded Carbon Hybrid for High-Performance Capacitive Deionization

Recent progress in graphene-based and ion-intercalation electrode materials for capacitive deionization

Preparation and Application of Electrodes in Capacitive Deionization (CDI): a State-of-Art Review

Single modular flow-electrode capacitive deionization using modified Prussian blue analogues as cation intercalation electrode for continuous water desalination

Boosted brackish water desalination and water softening by facilely designed MnO2/hierarchical porous carbon as capacitive deionization electrode

Charged functional groups modified porous spherical hollow carbon material as CDI electrode for salty water desalination