Abstract:With the development of society and increased demand for clean energy, as an efficient energy storage device, lithium-ion batteries are widely used in various fields. As they fail, a large number of waste lithium-ion batteries will be produced. If not handled properly, it will not only cause the loss of nonferrous metals but also cause serious environmental pollution. This article proposes a new concept of using waste lithium-ion battery material to directly reuse it for the next generation of secondary batteries. It is a new strategy to prepare a dual-function regeneration material by direct regeneration technology, which is not limited to the traditional idea of valuable metal recovery, and solve the problem of raw material source and waste recycling of the new battery system. Waste lithium cobaltite cathode powder was used to supplement the metal ions Li+, Mg2+, and Ce4+ for heat treatment. The demand of direct regeneration and synergistic modification was achieved in a green and efficient way. The discharge capacity of the material is 226.346 mAh/g at 4.6 V. In this study, the dual-function regeneration strategy is expected to accelerate the industrialization process of waste lithium-ion batteries.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acssuschemeng.1c03266.Element content analysis of original waste lithium cobalt oxide powder, XRD derived data table, and AC impedance-derived data table (PDF)This article has not yet been cited by other publications.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the efficient recovery and reuse of cathode materials from spent lithium - ion batteries. Specifically, the paper proposes a bifunctional regeneration strategy to prepare regenerated lithium - cobalt - oxide materials with good stable cycling performance at high voltages through direct regeneration technology and co - doping with Mg and Ce. This method aims to overcome the problems of high energy consumption and secondary pollution in traditional recovery methods such as pyrometallurgy and hydrometallurgy, and improve the electrochemical performance of the regenerated materials to reach or even exceed that of the original materials, thereby accelerating the industrialized recovery process of spent lithium - ion batteries. The paper mentions that with the development of society and the increasing demand for clean energy, lithium - ion batteries, as efficient energy storage devices, are widely used in various fields. However, when these batteries fail, a large number of spent lithium - ion batteries will be generated. If not properly disposed of, it will not only cause the loss of non - ferrous metals but also lead to serious environmental pollution. Therefore, how to effectively recover and reuse these spent lithium - ion batteries has become an important research direction. The bifunctional regeneration strategy proposed in this study not only solves the recovery problem of cathode materials from spent lithium - ion batteries but also improves the electrochemical performance of the regenerated materials, especially their stable cycling performance at high voltages. The experimental results show that the discharge capacity of the materials prepared by this method reaches 226.346 mAh/g at a voltage of 4.6 V, showing excellent electrochemical performance. This indicates that the bifunctional regeneration strategy not only solves the problem of recycling spent lithium - ion batteries but also provides new ideas and technical support for the development of a new generation of high - performance lithium - ion batteries.

Dual-Function Regeneration of Waste Lithium Cobalt Oxide for Stable High Voltage Cycle Performance

Toward High Voltage Performance of LiCoO 2 Cathode Materials Directly Regenerated with a Bulk and Surface Synergistic Approach from Spent Lithium-Ion Batteries

Resource recovery and regeneration strategies for spent lithium-ion batteries: Toward sustainable high-value cathode materials

Collaborative Regeneration of Structural Evolution for High-Performance of LiCoO 2 Materials from Spent Lithium-Ion Batteries

Sustainable Upcycling of Spent LiCoO2 to an Ultra-Stable Battery Cathode at High Voltage

Effective Upcycling of Degraded NCM Cathode Materials Assisted by Surface Engineering for High‐Performance Lithium‐Ion Batteries

Direct regeneration of spent cathode materials by redox system

Sustainable upcycling of mixed spent cathodes to a high-voltage polyanionic cathode material

Direct regeneration of cathode materials in spent lithium-ion batteries toward closed-loop recycling and sustainability

Efficient Extraction of Lithium from Anode for Direct Regeneration of Cathode Materials of Spent Li-Ion Batteries

Sustainable upcycling of spent LiCoO<sub>2</sub> to an ultra-stable battery cathode at high voltage

Regeneration of Black Powders of Waste Lithium Iron Phosphate Battery Produced by Large‐Scale Industrialization

Boosting efficient and low-energy solid phase regeneration for single crystal LiNi0.6Co0.2Mn0.2O2 via highly selective leaching and its industrial application

All-element recovery and regeneration of mixed LiNixCoyMn1- x- yO2/LiFePO4 cathode materials by synergistic redox processes

The auto-oxidative relithiation of spent cathode materials at low temperature environment for efficient and sustainable regeneration

The regeneration and electrochemical performance study of NCM622 cathode materials

Innovative Electrochemical Strategy to Recovery of Cathode and Efficient Lithium Leaching from Spent Lithium-Ion Batteries

Direct Regenerating Cathode Materials from Spent Lithium‐Ion Batteries

Efficient Direct Recycling of Degraded LiMn 2 O 4 Cathodes by One-Step Hydrothermal Relithiation

Direct Regeneration of High-Value LiFePO 4 Cathode Materials with Nitrogen Doped Carbon Coating

A green, efficient, closed-loop direct regeneration technology for reconstructing of the LiNi0.5Co0.2Mn0.3O2 cathode material from spent lithium-ion batteries