Abstract:Polyimide (PI) has been widely used as the alignment layers for twisted-nematic (TN) thin film transistor driven liquid crystal display devices (TFT-LCDs). However, the currently PI alignment layers based on 1,2,3,4-cyclobutanetetracarboxylic dianhydride (CBDA) and common aromatic diamines usually showed low alignment abilities to rigid-rod liquid crystal (LC) molecule with low pretilt angles. Thus, in the current work, a series of novel PI precursors, poly(amic acid)s (PAAs) alignment agents were developed. For this purpose, four PAAs have been prepared from a newly developed ester-linked aromatic diamine containing tert -butyl-substituted cyclohexyl in the side chain, 4'- tert -butyl-cyclohexyl-3,5-diaminobenzoate (DABC) and various dianhydrides. The PAAs included three ones derived from aliphatic or alicyclic dianhydrides, including PAA-1 (BDA-DABC) from 1,2,3,4-butanetetracarboxylic dianhydride (BDA), PAA-2 (CBDA-DABC) from CBDA, and PAA-3 (DMCBDA-DABC) from 1,3-dimethyl-1,2,3,4-cyclobutanetetracarboxylic dianhydride (DMCBDA), and one from aromatic dianhydride, 2,2′-bis(3,4-dicarboxylphenyl)hexafluoropropane dianhydride (6FDA) (PAA-4, 6FDA-DABC). The derived PAAs were used as the alignment agents to fabricate the minicells of twisted-nematic (TN) modes of thin-film transistor driven liquid crystal display (TFT-LCDs). The PI alignment layers obtained by the thermal imidization of the corresponding PAAs, followed by rubbing treatments showed good alignment ability to the liquid crystal (LC) molecules with the pretilt angles ( θ p ) in the range of 1.46 ~ 7.02°. PI-3 (DMCBDA-DABC) showed the highest θ p of 7.02°, while PI-4 (6FDA-DABC) exhibited the lowest one of 1.46°. The semi-aromatic PI-1 ~ PI-3 layers showed higher optical transmittance than that of the wholly aromatic PI-4 counterpart. PI-4 layer exhibited the lowest voltage holding ratio (VHR) of 91.32% at 60 °C, which was apparently lower than those of the semi-aromatic PI-1 ~ PI-3 counterparts (> 96.00%). In addition, the semi-alicyclic PI alignment layers (PI-2 and PI-3) showed lower residual direct circuit voltages (RDC) than that of the wholly aromatic PI-4. At last, the photoalignment behaviors of the PI alignment layers were preliminarily investigated. Only PI-2 and PI-3 exhibited the alignment ability to the LC molecules after being treated with the linear polarized ultraviolet (LPUV) with the wavelength of 254 nm.

Ternary copolymerization photosensitive polyimide containing flexible group for liquid crystal alignment film

Soluble polyimide as liquid crystal perpendicular alignment layer

CINNAMATE_CONTAINING POLYIMIDE AND ITS FUNCTION AS LIQUID CRYSTAL PHOTOALIGNMENT LAYER

Preparation and characterization of photo‐decomposable ester‐containing semi‐alicyclic polyimide alignment layers for potential applications in in‐plane switching thin‐film transistor liquid crystal display devices

Preparation and properties of laterally tert-butyl-substituted cyclohexyl-containing polyimide alignment layers with high pretilt angles for potential applications in twisted-nematic TFT-LCDs

A Novel Soluble Azo Polyimide and Its Application As Liquid Crystal Photo-Alignment Layer

Mesogen-co-polymerized Transparent Polyimide As a Liquid-Crystal Alignment Layer with Enhanced Anchoring Energy

Synthesis and Characterization of A Novel Polyurethane-Based Photo-Alignment Layer Polymer for Liquid Crystal Displays

Polyimides with main-chain photosensitive groups: Synthesis, characterization and their properties as liquid crystal alignment layers

Preparation and alignment properties of photosensitive polyimide containing benzophenone in main chain

Liquid Crystal Alignment on Polyimide Langmuir-Blodgett Films

Preparation and Characterization of Semi-Alicyclic Polyimide Resins and the Derived Alignment Layers for Liquid Crystal Display Technology

Pretilt angle control of liquid crystal molecules by photoaligned films of azobenzene-containing polyimide with a different content of side-chain

Property of Polyimide Alignment Layer Used for STN Liquid Crystal Display

Synthesis of a Novel Rigid Semi-Alicyclic Dianhydride and Its Copolymerized Transparent Polyimide Films' Properties

Synthesis and Characterization of Semi-Alicyclic Transparent Polyimide Films Containing Benzanilide and Fluorene Units with Improved High-Temperature Dimensional Stability and Low-Optical Retardations

Synthesis and Properties of Optically Transparent Fluoro-Containing Polyimide Films with Reduced Linear Coefficients of Thermal Expansion from Organo-Soluble Resins Derived from Aromatic Diamine with Benzanilide Units

Effect of simultaneously introduced bulky pendent group and amide unit on optical transparency and dimensional stability of polyimide film

Dependence of pretilt angle on orientation and conformation of side chain with different chemical structure in polyimide film surface

Synthesis and Characterization of Biphenyl Polyimide Containing Alkyl Sulfide Structure

Structure and Properties of Thermoplastic Polyimide Based on 4', 4'-(Oxybis (methylene)) Bis ([1.1'- Bipheny]3-Amine) Diamine