Abstract:Most of the previous researches on the cascaded packed-bed latent heat storage (CPTES) system are the thermal performance optimization based on numerical calculation. Experimental studies are few and mainly focus on single design parameter at low-temperature conditions. Lack of the detailed temperature - flow field experimental data and optimization scheme for the CPTES system. In this paper, an optimized two-layered filling structure of packed-bed heat storage system (OT-PTES) was proposed, which considers melting temperature of phase change material (PCM), capsule diameter, and filling volume ratio. The heat transfer process of PCM capsule and heat transfer fluid (HTF) during charging/discharging process were studied in detail by experiments. Under consistent working conditions, the average charging/discharging rate, total heat capacity, overall efficiency, and exergy efficiency was evaluated. And the influences of HTF inlet flow and the volume filling ratio of two-layered on thermal performance were analyzed. Finally, the concentric diffusion model was used to simulate the system to further optimize its hierarchical structure. The results are concluded as follows: (1) The temperature difference between PCM capsule and HTF at the interface changes continuously, and there is also an obvious temperature gradient in the radial direction of HTF, which improves the heat transfer efficiency. (2) Through experiments, the packed-bed with single large/small size PCM capsules are compared with the OT-PTES system. The overall efficiency of the latter is 74.2%, increased by 3.38% and 8.28%, and the exergy efficiency is 62.7%, increased by 7.5% and 52%. It is proved that the OT-PTES system has better charging/discharging performance. (3) When the volume filling rate = 1/2, the system has the best thermal performance (75.04%) and exergy efficiency (67.1%). (4) The numerical simulation results show that the overall performance of the packedbed is optimal when the capsule size composition is 20-30 mm and the temperature difference of PCMs melting point is 60 celcius. In summary, OT-PTES is an optimized system with better heat storage performance. This study can provide experimental data support for the optimal design of the PLTES system and useful guidance for industrial applications.

Phase change material thermal energy storage design of packed bed units

Pore-scale numerical investigation on the thermal storage properties of packed-bed systems with phase change material microcapsules

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Thermal Performance Analysis of Packed-Bed Thermal Energy Storage with Radial Gradient Arrangement for Phase Change Materials

Thermal performance analysis and optimization of cascaded packed bed latent heat storage tank

A numerical investigation into the charge behaviour of a spherical phase change material particle for high temperature thermal energy storage in packed beds

Thermal investigation of PCM-based high temperature thermal energy storage in packed bed

Numerical investigation on melting and energy storage density enhancement of phase change material in a horizontal cylindrical container

Thermal performance simulations of a packed bed cool thermal energy storage system using n-tetradecane as phase change material

Thermal Energy Storage Characteristics of Packed Bed Encapsulating Spherical Capsules with Composite Phase Change Materials

Thermal Performance of Structured Packed Bed with Encapsulated Phase Change Materials

Heat-Storage Performance Optimization for Packed Bed Using Cascaded PCMs Capsules

Phase change material-based thermal energy storage

Performance of a New Packed Bed Using Stratified Phase Change Capsules

Recent Progress in Phase Change Materials Storage Containers: Geometries, Design Considerations and Heat Transfer Improvement Methods

Influence of tank-to-particle diameter ratio on thermal storage performance of random packed-bed with spherical macro-encapsulated phase change materials

Optimizing the design of composite phase change materials for high thermal power density

Numerical Study on Thermal Performance and Flow Characteristic of Phase Change Material Heat Storage Unit with Capsule-Shaped Structure

Experimental and numerical study on thermal performance and inlet and outlet structure optimization of phase change heat storage tank

Optimization Design and Performance Investigation on the Cascaded Packed-Bed Thermal Energy Storage System with Spherical Capsules

Enhancing the Phase Change Material Based Shell-Tube Thermal Energy Storage Units with Unique Hybrid Fins