Predictive power control strategy without grid voltage sensors of the Vienna rectifier

Tao Yang,Lan Chen,Yiru Miao
DOI: https://doi.org/10.1049/pel2.12707
IF: 2
2024-05-22
IET Power Electronics
Abstract:A predictive power control strategy without grid voltage sensors of the three‐phase six‐switch Vienna rectifier is proposed to reduce the hardware cost and complexity of high‐power PWM rectifier system. Finally, the effectiveness of the proposed control strategy is verified by simulation and experiment. This paper proposes a predictive power control strategy for the three‐phase, six‐switch Vienna rectifier without grid voltage sensors to reduce the hardware cost and complexity of a high‐power PWM rectifier system. Firstly, an algorithm for calculating the AC‐side voltage in the αβ coordinate system is derived according to the operating principle of the Vienna rectifier, and a voltage observer is constructed by combining a second‐order low‐pass filter to estimate the grid voltage. Secondly, a soft start method is designed to solve the problem that the rectifier is prone to inrush current when it is started. Furthermore, the control method of grid voltage sensorless is combined with predictive power control with good dynamic characteristics and simple parameter settings to form the control strategy proposed in this paper. Finally, simulation analysis and experimental verification are carried out on the proposed control strategy. Simulation and experimental results show that the grid voltage estimation has high accuracy, a good surge current suppression effect, unit power factor operation, low input current harmonic content, and good dynamic and steady‐state performance. Therefore, the correctness and effectiveness of the strategy proposed in this paper are verified.
engineering, electrical & electronic
What problem does this paper attempt to address?