Abstract:Natural gas with high CO2 content is a readily available resource, whose application for synthesis gas (syngas) production through dry reforming is strictly limited to processes that require low H2/CO ratios. In a recent work we have demonstrated that methanol production through a process scheme based on combined reforming of methane (with CO2+H2O) becomes a viable alternative from both technical and economic viewpoints. The use of a H2 separation membrane, as well as a partial H2 reinjection into the loop reactor, has been considered for the syngas composition adjustment to stoichiometric conditions (M≈2). The reformer and the methanol synthesis reactor were assumed to be working at thermodynamic equilibrium conditions, i.e. at 950°C and 20bar for the former, and at 250°C and 71bar for the latter. By using a natural gas feed containing 30 % CO2 and H2O/CH4=2, it is feasible to operate the synthesis reactor with a lower recycle ratio, as well as a CO2 concentration close to the one employed in industrial practice. Under the operating conditions mentioned above, the use of combined reforming for methanol synthesis turns out to be economically advantageous over the classical steam reforming process.In this work a study of the feed flexibility for combined reforming is carried out taking into account the existence of gas fields with CO2 contents higher than 30 %. Feed mixtures containing 35 % and 40 % CO2 were analyzed, while maintaining the operating conditions for the reformer (P, T, H2O/CH4) and the synthesis reactor (P, T, M). For comparative purposes, a methanol plant producing 400,000 mtpy was considered. A higher CO2 content in the feed does not significantly alter the CH4 conversion, but increases the CO2 conversion and lowers the H2/CO ratio. Consequently, it is necessary to increase the separation and reinjection of H2 to keep stoichiometric conditions in the synthesis reactor. However, a moderate increase in CO2 concentration in the synthesis reactor cannot be avoided. It is also shown that the recycle ratio should be markedly reduced in order to achieve stable operation. This situation reduces the operating cost of the recycle compressor. On the other hand, the flow of CH4+CO2 to the reformer should be increased for a constant methanol production, which in turn affects the reformer’s energy balance. The main operating costs of the methanol plant, with respect to the reference case (CO2/CH4=0.43), grow for CO2/CH4=0.55 and CO2/CH4=0.67 by 9.5 % and 25 %, respectively. This preliminary technical and economic analysis shows that combined reforming of natural gas with CO2 content up to 40 % is a feasible process to produce methanol without CO2 removal.

Combined Production of Hydrogen and Methanol without CO2 Emission Based on Matrix Conversion of Natural Gas

A near-zero carbon emission methanol production through CO2 hydrogenation integrated with renewable hydrogen: Process analysis, modification and evaluation

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

Hydrogen Production Via Ammonia from Methane Integrated with Enhanced Oil Recovery: A Techno-Economic Analysis

Thermally self-sufficient process for single-step coproduction of methanol and dimethyl ether by CO 2 hydrogenation

A near-zero carbon emission methanol production through CO 2 hydrogenation integrated with renewable hydrogen: Process analysis, modification and evaluation

Process Design for the Directly Coupled Production of Methanol and Formaldehyde Based on CO2

Flexible Methanol Production Process Using Biomass/ Municipal Solid Waste and Hydrogen Produced by Electrolysis and Natural Gas Pyrolysis

Progress of Commercial Technologies for Producing Syngas and Hydrogen from Hydrocarbon Gases

Green hydrogen coupling with CO2 utilization of coal-to-methanol for high methanol productivity and low CO2 emission

Enhancing Biomass-to-Liquid conversion through synergistic integration of natural gas pyrolysis: process options and environmental implications

Evaluation of alternative processes of methanol production from CO2: Design, optimization, control, techno-economic, and environmental analysis

Co-Production of Dimethyl Carbonate, Dimethoxymethane and Dimethyl Ether from Methanol: Process Design and Exergy Analysis

Carbon-negative co-production of methanol and activated carbon from bagasse pyrolysis, physical activation, chemical looping, and methanol synthesis

Techno-Economic Analysis of Integrating a CO2 Hydrogenation-to-Methanol Unit with a Coal-to-Methanol Process for CO2 Reduction

An investigation of synthetic fuel production via chemical looping

Feed Flexibility of CH4 Combined Reforming for Methanol Production

Integrated Capture and Conversion of CO2 to Methanol in a Post‐Combustion Capture Solvent: Heterogeneous Catalysts for Selective CN Bond Cleavage

Utilizing carbon dioxide from refinery for methanol and electricity co-production: System design and economic assessment

An Analysis of the Methane Cracking Process for CO2-Free Hydrogen Production Using Thermodynamic Methodologies

Integrated CO 2 capture and conversion into methanol units: Assessing techno-economic and environmental aspects compared to CO 2 into SNG alternative