Abstract:Objective The debate on the superiority of single- or double-bundle for anterior cruciate ligament reconstruction has not ceased. The comparative studies on intra-articular biomechanics after different surgical reconstructions are rare. This study is to evaluate the biomechanical stress distribution intra-knee after single- and double-bundle anterior cruciate ligament reconstruction by three-dimensional finite element analysis, and to observe the change of stress concentration under the condition of vertical gradient loads. Methods In this study, magnetic resonance imaging data were extracted from patients and healthy controls for biomechanical analysis. Patients included in the three models were matched in age and sex. The strength and distribution of induced stresses were analyzed in two frequently used procedures, anatomical single-bundle anterior cruciate ligament reconstruction and anatomical double-bundle anterior cruciate ligament reconstruction, using femoral-graft-tibial system under different loads, to mimic a post-operation mechanical motion. The three-dimensional finite-element models for normal ligament and two surgical methods were applied. A vertical force simulating daily walking was performed on the models to assess the interfacial stresses and displacements of intra-articular tissues and ligaments. The evaluation results mainly included the stress of each part of ligament and meniscus. The stress values of different parts of three models were extracted and compared. Results The stress of ligament/graft at femoral side of three finite-element models was significantly higher than at tibial side, while the highest level was observed in single-bundle reconstruction finite-element model. With the increase of force, the maximum stress in the medial (7.1-7.1 MPa) and lateral (4.9-7.4 MPa) meniscus of single-bundle reconstruction finite-element model shifted from the anterior horn to the central area (p = 0.0161, 0.0479, respectively). The stress was shown to be at a lower level at femoral side and posterior cruciate ligament of intra-knee in two reconstruction finite-element models than that in normal finite-element models, while presented higher level at the tibial side than normal knee (p = 0.3528). The displacement of the femoral side and intra-knee areas in reconstruction finite-element models was greater than that in normal finite-element model (p = 0.0855). Conclusion Compared with the single-bundle technique, the graft of double-bundle anterior cruciate ligament reconstruction has better stress dissipation effect and can prevent postoperative meniscus tear more effectively.

Relationships Between Running Biomechanics and Femoral Articular Cartilage Thickness and Composition in Anterior Cruciate Ligament Reconstruction Patients

The Influence of Knee Position on Ultrasound Imaging of Femoral Cartilage in Individuals with Anterior Cruciate Ligament Reconstruction

The biomechanical interdependence between the anterior cruciate ligament replacement graft and the medial meniscus

The Finite Element Analysis of Three Grafts in the Anterior Cruciate Ligament Reconstruction

Anterior cruciate ligament reconstruction and cartilage contact forces—A 3D computational simulation

Hip joint biomechanics in those with and without post-traumatic knee osteoarthritis after anterior cruciate ligament injury

Relationship between altered knee kinematics and subchondral bone remodeling in a clinically translational model of ACL injury

Effect of Running Speed on Knee Biomechanics in Collegiate Athletes Following Anterior Cruciate Ligament Reconstruction

An in Vivo Prediction of Anisometry and Strain in Anterior Cruciate Ligament Reconstruction - A Combined Magnetic Resonance and Dual Fluoroscopic Imaging Analysis.

The Science of Anterior Cruciate Ligament Rehabilitation

Surgical parameters influence paediatric knee kinematics and cartilage stresses in anterior cruciate ligament reconstruction: Navigating subject-specific variability using neuromusculoskeletal-finite element modelling analysis

Intra-Articular Biomechanical Changes of the Meniscus and Ligaments During Stance Phase of Gait Circle after Different Anterior Cruciate Ligament Reconstruction Surgical Procedures: A Finite Element Analysis

Dual Fluoroscopic Imaging and CT-based Finite Element Modelling to Estimate Forces and Stresses of Grafts in Anatomical Single-Bundle ACL Reconstruction with Different Femoral Tunnels.

The Effect of Anterior Cruciate Ligament Injury on the Biomechanical Behavior of Human Knee Joint

Associations Between Body Mass Index, Gait Biomechanics, and In Vivo Cartilage Function After Exercise in Those With Anterior Cruciate Ligament Reconstruction

The biomechanics of anterior cruciate ligament rehabilitation and reconstruction

Abnormal Rotational Knee Motion during Running after Anterior Cruciate Ligament Reconstruction

Hip and knee joints mechanics and asymmetries in individuals with a history of anterior cruciate ligament reconstruction during overground running

Varying femoral tunnels between the anatomical footprint and isometric positions: effect on kinematics of the anterior cruciate ligament-reconstructed knee

In Vitro Assessment of Knee Joint Biomechanics Using a Virtual Anterior Cruciate Ligament Reconstruction

The effect of bony morphology on anterior cruciate ligament injury and surgery