Abstract:The wastewater generated by the pharmaceutical industry poses a risk to the environment due to undesirable characteristics such as low biodegradability, high levels of contaminants, and the presence of suspended solids, in addition to the high load of organic matter due to the presence of drugs and other emerging products in the effluent. This study aims to reduce the impact of wastewater pollution by removing amoxicillin (AMO) antibiotics as an organic pollutant. In this concept, two synthesized catalysts, NiAl2O4 and ZnO, are sensitive oxides to light energy. The prepared materials were then characterized using X-ray diffraction, UV–vis solid reflectance diffuse, Raman spectroscopy, scanning electron microscopy, BET, and ATR-FTIR spectroscopy. The effects of principal operating parameters under sunlight, namely, the percentage of the mixture of NiAl2O4 and ZnO, the pH of the medium, and the initial concentration of the antibiotic were studied experimentally to determine the optimal conditions for achieving a high degradation rate. The results showed that photodegradation is higher at a pH of 6, with a weight percentage of the mixture of 50% for both catalysts in 1 g/L of the total catalyst dose. Then, the effect of the initial concentration of AMO on the photodegradation reaction showed an important influence on the photodegradation process; as the degradation rate decreases, the initial AMO concentration increases. A high degradation rate of 92% was obtained for an initial AMO concentration of 10 mg/L and a pH of 6. The kinetic study of degradation established that the first-order model and the Langmuir–Hinshelwood (LH) mechanism fit the experimental data perfectly. The study showed the success of using heterosystem photocatalysts and sustainable energy for effective pharmaceutical removal, which can be extended to treat wastewater with other organic emerging pollutants. On the other hand, modeling was introduced using Gaussian process regression (GPR) to predict the degradation rate of AMO under sunlight in the presence of heterogeneous ZnO and NiAl2O4 systems. The model evaluation criteria of GPR in terms of statistical coefficients and errors show very interesting results and the performance of the model used. Where statistical coefficients were close to one (R = 0.9981), statistical errors were very small (RMSE = 0.1943 and MAE = 0.0518). The results suggest that the model has a strong predictive power and can be used to optimize the process of AMO removal from wastewater.

Photocatalysis of low-density polyethylene using FKMW-ZnO NPs: optimization and predication model using a radial basis function neural network ensemble system

Validity of zinc oxide nanoparticles biosynthesized in food wastes extract in treating real samples of printing ink wastewater; prediction models using feed-forward neural network (FFNN)

Application of machine learning models to improve the prediction of pesticide photodegradation in water by ZnO-based photocatalysts

Photo-Catalytic Activity Improvement for Organic Pollutant Removal in Wastewater using Zinc Oxide Quantum Dots: An Experimental and Modeling Study

A convenient strategy for mitigating microplastics in wastewater treatment using natural light and ZnO nanoparticles as photocatalysts: A mechanistic study

Optimizing the preparatory conditions of nano particle photocatalyst ZnO/SnO2 coupled oxide based on the methods of experimental design and modeling

Modeling of photodegradation process to remove the higher concentration of environmental pollution

Modelling and optimisation of p-nitrophenol removal process using homogeneous photo-periodate (UV/KPI) advanced oxidation process

Facile synthesis of ZnO nanospheres by co-precipitation method for photocatalytic degradation of azo dyes: optimization via response surface methodology

Structural, Optical, and Renewable Energy-Assisted Photocatalytic Dye Degradation Studies of ZnO, CuZnO, and CoZnO Nanostructures for Wastewater Treatment

Artificial intelligence-enabled optimization of Fe/Zn@biochar photocatalyst for 2,6-dichlorophenol removal from petrochemical wastewater: A techno-economic perspective

Modeling polystyrene nanoplastics degradation in water via photo-Fenton treatment: A shrinking-particle approach

Modeling and optimization of heterogeneous photo-Fenton process with response surface methodology and artificial neural networks

Sustainable Photodegradation of Amoxicillin in Wastewater with a Nickel Aluminate and ZnO Heterosystem Oxides: Experimental and Gaussian Process Regression Modeling Studies

EFFECT OF THERMO-PHOTOCATALYTIC PROCESS USING ZINC OXIDE ON DEGRADATION OF MACRO/MICRO-PLASTIC IN AQUEOUS ENVIRONMENT

Photodegradation of dye using Polythiophene/ZnO nanocomposite: A computational approach

Biosynthesis And Characterization Of A Novel Supported Nanocatalyst For The Methylene Blue Dye Photodegradation: Machine Learning Modeling And Photocatalytic Activity

Modeling and optimization study on degradation of organic contaminants using nZVI activated persulfate based on response surface methodology and artificial neural network: a case study of benzene as the model pollutant

Green synthesis of zinc oxide nanoparticles using Albizia procera leaf extract: Degradation of methylene blue dye via Advanced Oxidation Process and Box–Behnken Design

Optimization of photocatalytic degradation conditions and toxicity assessment of norfloxacin under visible light by new lamellar structure magnetic ZnO/g-C3N4

Integrating machine learning with experimental investigation for optimizing photocatalytic degradation of Rhodamine B using neodymium-doped titanium dioxide: a comprehensive approach with toxicity assessment