Green synthesis of zinc oxide nanoparticles using Albizia procera leaf extract: Degradation of methylene blue dye via Advanced Oxidation Process and Box–Behnken Design

Hajer Chemingui,Malak Kahloul,Badra El Abed,Taissire Ben Amor,Amor Hafiane
DOI: https://doi.org/10.1007/s10098-024-02799-x
IF: 4.3
2024-04-11
Clean Technologies and Environmental Policy
Abstract:Through this research, zinc oxide nanoparticles (ZnO NPs) were successfully synthesized via easy route "green process" using plant extract of Albizia procera . The purpose of this research is to investigate the degradation of methylene blue (MB) dye via advanced oxidation process (AOP) in the presence of Hydrogen peroxide (H 2 O 2 ) and the ZnO photocatalyst under visible light irradiation. The X-ray diffraction (XRD) results confirmed that the ZnO NPs had a hexagonal wurtzite structure. The average crystalline size of around 20 nm was observed by the Debye–Scherrer formula. The dynamic light scattering (DLS) showed a range of sizes 23 nm. This study aims to analyze the influence of operating parameters and their interactive effect on the overall removal efficiency of the targeted component by response surface methodology (RSM). The Box–Behnken design (BBD) in RSM was used to optimize several process variables. In order to optimize the responses of MB elimination rate, parameters such as pH (A: 3–11), molar ratio [H 2 O 2 ]/[ZnO] (B:1–3), concentration dye (C: 10–30 mg L −1 ), and contact time (D:30–70 min) were used as independent factors. The values obtained from the experiment and model predictions were discovered to be in adequate approval, and the model equation's performance confirmed the experimental observation with only a small divergence. These results confirmed the efficient environmental remediation of heterogeneous photocatalytic process thanks to ZnO NPs.
environmental sciences,green & sustainable science & technology,engineering, environmental
What problem does this paper attempt to address?