Abstract:The detailed knowledge of the Milky Way radio emission is important to characterize galactic foregrounds masking extragalactic and cosmological signals. The update of the global sky models describing radio emissions over a very large spectral band requires high sensitivity experiments capable of observing large sky areas with long integration times. Here, we present the design of a new 10 GHz (X-band) polarimeter digital back-end to map the polarization components of the galactic synchrotron radiation field of the Northern Hemisphere sky. The design follows the digital processing trends in radio astronomy and implements a large bandwidth (1 GHz) digital complex cross-correlator to extract the Stokes parameters of the incoming synchrotron radiation field. The hardware constraints cover the implemented VLSI hardware description language code and the preliminary results. The implementation is based on the simultaneous digitized acquisition of the Cartesian components of the two linear receiver polarization channels. The design strategy involves a double data rate acquisition of the ADC interleaved parallel bus, and field programmable gate array device programming at the register transfer mode. The digital core of the back-end is capable of processing 32 Gbps and is built around an Altera field programmable gate array clocked at 250 MHz, 1 GSps analog to digital converters and a clock generator. The control of the field programmable gate array internal signal delays and a convenient use of its phase locked loops provide the timing requirements to achieve the target bandwidths and sensitivity. This solution is convenient for radio astronomy experiments requiring large bandwidth, high functionality, high volume availability and low cost. Of particular interest, this correlator was developed for the Galactic Emission Mapping project and is suitable for large sky area polarization continuum surveys. The solutions may also be adapted to be used at signal processing subsystem levels for large projects like the square kilometer array testbeds.

Design of an IF section for a Galactic Emission Mapping experiment

Design of an IF section for C band polarimetry

A high performance cost-effective digital complex correlator for an X-band polarimetry survey

Intermediate Frequency Circuit Design for a 60ghz LFMCW Radar

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

Design of rf front end for cavity beam position monitor based on ics *

Design of the tertiary optical system for the Large Latin American Millimeter Array radio telescope

A 5 GHz LNA for a Radio-Astronomy Experiment

An Integrated System at the Bleien Observatory for Mapping the Galaxy

Design and Performance of 30/40 GHz Diplexed Focal Plane for BICEP Array

The Simons Observatory: Design, Optimization, and Performance of Low-Frequency Detectors

Site Evaluation and RFI spectrum measurements in Portugal at the frequency range 0.408-10 GHz for a GEM polarized galactic radio emission experiment

Development of the 220/270 GHz Receiver of BICEP Array

Digital Frequency Domain Multiplexer for mm-Wavelength Telescopes

Optimization of Antenna Performance for Global 21-cm Observations and Verification Using Scaled Copies

Spillover and diffraction sidelobe contamination in a double-shielded experiment for mapping Galactic synchrotron emission

Next Generation Sub-Millimeter Wave Focal Plane Array Coupling Concepts: an ESA TRP Project to Develop Multichroic Focal Plane Pixels for Future CMB Polarization Experiments

The BINGO Project IV: Simulations for mission performance assessment and preliminary component separation steps

The Simons Observatory Microwave SQUID Multiplexing Detector Module Design

How Do We Design the Interferometric System Focused on the Analog and Digital Backend and the Correlator for Scientifically Valuable ALMA Developments?

Low-noise Heterodyne Receiver for Electron Cyclotron Emission Imaging and Microwave Imaging Reflectometry.