Stability of Jahn Teller distortion in LaMnO3 under pressure: An x-ray absorption study

Aline Y. Ramos,Hélio C. N. Tolentino,Narcizo M. Souza-Neto,Jean-Paul Itié,Liliana Morales,Alberto Caneiro
DOI: https://doi.org/10.1103/PhysRevB.75.052103
2007-01-31
Abstract:The local environment of manganese atoms in LaMnO3 under pressure up to 15.3 GPa has been studied by x-ray absorption spectroscopy. For pressures below 8 GPa, no change is detected within the MnO6 octahedra. Above this pressure a continuous reduction of the long Mn-O distance takes place, however the octahedral distortion persists over the whole pressure range. At 15.3 GPa the average Jahn-Teller splitting of the distances is reduced by about one third, indicating that a total removal of the local Jahn-Teller distortion would occur only for pressures around 30 GPa, where metallization is reported to take place. A hysteresis in the long distance reduction is observed down to ambient pressure, suggesting the coexistence of MnO6 distorted and undistorted units.
Materials Science
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: How does the local environment of manganese atoms in LaMnO₃ (especially the distortion caused by the Jahn - Teller effect) change under high - pressure conditions. Specifically, the researchers hope to explore the local structural changes of LaMnO₃ under different pressures through X - ray absorption spectroscopy (XAS) technology, especially the relationship between the Jahn - Teller distortion and the insulator - metal transition. ### Main problems: 1. **Stability of Jahn - Teller distortion**: The MnO₆ octahedron in LaMnO₃ is distorted due to the Jahn - Teller effect, forming 4 short bonds and 2 long bonds. The researchers hope to understand the stability of this distortion under high - pressure conditions. 2. **Effect of high pressure on local structure**: Through X - ray absorption spectroscopy, the researchers hope to reveal the specific effect of high pressure on the local structure of the MnO₆ octahedron, especially the changes in long and short bonds. 3. **Relationship between Jahn - Teller distortion and insulator - metal transition**: LaMnO₃ undergoes an insulator - metal transition under high pressure, and the researchers hope to explore through experimental data whether this transition is related to the disappearance of the Jahn - Teller distortion. ### Research background: LaMnO₃ is a material with complex physical properties, especially showing antiferromagnetic semiconductor behavior in its ground state, and having an orthorhombic - distorted cubic perovskite lattice structure. The Jahn - Teller effect of Mn³⁺ ions causes the MnO₆ octahedron to be distorted, forming 4 short bonds and 2 long bonds. Previous studies have shown that high pressure can reduce lattice distortion and enhance carrier mobility, but the specific local structural changes have not been fully understood. ### Research methods: The authors used X - ray absorption spectroscopy (XAS) technology, especially near - edge X - ray absorption fine structure (XANES) and extended X - ray absorption fine structure (EXAFS), to study the local structural changes of LaMnO₃ in the range of 0 to 15.3 GPa. In the experiment, a diamond anvil cell device with perforations was used to overcome the difficulties in collecting XAS data under high - pressure conditions. ### Key findings: - Below 8 GPa, there is no obvious change in the local structure of the MnO₆ octahedron. - Above 8 GPa, the long bonds (Mn - O) gradually shorten, but the Jahn - Teller distortion still exists. - At 15.3 GPa, the Jahn - Teller splitting distance is reduced by about one - third, and it is speculated that the Jahn - Teller distortion will completely disappear at around 30 GPa. - When the pressure is released, a hysteresis phenomenon is observed, indicating that there may be coexistence of distorted and undistorted MnO₆ units. ### Conclusion: The research shows that the Jahn - Teller distortion in LaMnO₃ gradually weakens under high pressure, but will not completely disappear before 30 GPa. This implies that there is a close relationship between the Jahn - Teller distortion and the insulator - metal transition. In addition, the existence of the hysteresis phenomenon indicates that there may be coexistence of distorted and undistorted MnO₆ units under high pressure.