Characteristics of Dissimilar AA5083 and AA7050 Aluminium Alloys Friction Stir Butt Welded with Different Tool Axis Offsets

K. Subrahmanian,VR. Rajeev,VB. Renjith,KK. Ramachandran

DOI: https://doi.org/10.1007/s10904-024-03418-4

IF: 3.518

2024-09-27

Journal of Inorganic and Organometallic Polymers and Materials

Abstract:In the present research, the influence of tool axis offset on the microstructural and mechanical characteristics of dissimilar friction stir butt welded AA5083-H111 and AA7050-T7651 alloys is investigated. The experiments were conducted with the softer AA5083 alloy on the advancing side (AS) of the joint by varying the tool axis offset from zero to 1 mm, both towards the AS and retreating side (RS) of the joint with a 0.25 mm interval. The tool rotational speed, tool traverse speed, axial pressure and tool tilt angle, fixed by systematic preliminary trials, were held constant. The friction stir welded joints were subjected to microstructural (optical microscopy and EBSD analysis) and mechanical (microhardness and tensile properties) characterizations. The research outputs show that the position of tool axis has significant influence on the microstructure evolution and mechanical properties of the joints. The joint fabricated at 0.25 mm tool axis offset to the RS has exhibited the highest joint strength of 291 MPa (joint efficiency of 94.5%) and the joint efficiency is very sensitive to the change in tool axis offset. With this positional configuration of the alloys, the stir zone (SZ) is dominated by the dynamically recrystallized, strain free AA5083 alloy. The softening of the HAZ of the weaker AA5083 alloy (for higher tool axis offset to AA7050 alloy) and the weakening of the of SZ bottom (for low tool offset to AA7050 alloy and tool axis offset to AA5083 alloy) are the main factors which determine the location of fracture and the strength of the joints. In FSW of dissimilar 7xxx and 5xxx alloys, for better joint efficiency, positional configuration of alloys and appropriate selection of tool axis offset are very important.

polymer science