Abstract:This paper studies a high-precision etching process based on focused ion beam static trimming of the defective mass of fused silica hemispherical resonators to eliminate frequency splitting. This trimming method effectively overcomes the shortcomings of inefficiency and poor robustness, and the accuracy is seriously dependent on the stability of the trimming equipment in the traditional approach based on the harmonic form of trimming. The vibration model of an imperfect hemispherical resonator is firstly established by equating structural defects into point mass defective units, revealing that the frequency splitting is a function of the size of the equivalent defect mass and that the angular position of the stiffness axis is determined by the spatial distribution of the defect mass, which further elucidates that the frequency splitting of the resonator is the equivalent form of the defect mass on its low-frequency axis. To validate the accuracy of the present method, a simulation model of the imperfect resonator is established, and the results show that the theoretical model is in good agreement with the finite element method. Then, a high-precision nonlinear parameter identification model containing frequency splitting and low-frequency axis azimuth parameters is established based on the standing wave oscillation effect and spectral analysis, and the frequency splitting and low-frequency axis azimuth are identified by analyzing the vibration function of the hemispherical resonator. Finally, based on the parameter identification results and the ion beam removal function analysis, an ion beam trimming process is designed to eliminate frequency splitting by trimming the defective mass on the low-frequency axis. The results show that the frequency splitting after mass trimming is better than 0.001 Hz, significantly improving the hemispherical resonator's performance.

Frequency split suppression of fused silica micro shell resonator based on rotating forming process

Effects of Non-Ideal Frequency Splits on Linear Parametric Resonance in MEMS Mode-Split Gyroscopes

Frequency splitting of hemispherical resonators trimmed with focused ion beams

Research on the Configuration Optimization of All-Metal Micro Resonant Hemisphere

Achieving mode detection and precise mechanical trimming of uncoated micro shell resonator using interdigital electrode

Generalized frequency shift and attenuation in simply-supported micro/nano-beam resonators with thermoelastic dissipation

The influence of photothermal effect on the resonance frequency of fused silica micro hemispherical resonator

Tunable Fano Resonances Based on Two-Beam Interference in Microring Resonator

The High Performance Synchronous Trimming Method For Fused Silica Hemispherical Resonator

Dynamic modelling and quality factor evaluation of hemispherical shell resonators

Decreasing Frequency Splits of Hemispherical Resonators by Chemical Etching

Achieving Sub-Hz Frequency Symmetry in Micro-Glassblown Wineglass Resonators

Research on the Time-Domain Measurement Method of Low-Frequency Splitting for Hemispherical Resonator

High Precision Mass Balancing Method for the Fourth Harmonic of Mass Defect of Fused Quartz Hemispherical Resonator Based on Ion Beam Etching Process

A Novel Mechanical Frequency Tuning Method Based on Mass-Stiffness Decoupling for MEMS Gyroscopes

Manufacture of Hemispherical Shell and Surrounding Eave-Shaped Electrodes

Frequency Splitting Phenomenon of Dual Transverse Modes in a Nd:YAG Laser

High-frequency vibration of beveled crystal plates by using subregional geometric fitting method

Strain-Induced Frequency Splitting in PT Symmetric Coupled Silicon Resonators

Tunable coupling-induced resonance splitting in self-coupled Silicon ring cavity with robust spectral characteristics

Geometrical compensation for mode-matching of a (100) silicon ring resonator for a vibratory gyroscope