Controlled Parameter Modulations in Secure Digital Signal Transmissions

P. Palaniyandi,M. Lakshmanan

DOI: https://doi.org/10.1142/S021812740701972X

2006-10-26

Abstract:We propose a simple method for secure digital signal transmission by making some modifications in the single-step parameter modulation technique proposed earlier into overcome certain inherent deficiencies. In the modified method, the parameter modulation is effectively regulated or controlled by the chaotic signal obtained from the transmitting chaotic system so that it has the maximum security. Then, the same idea is also extended to the multistep parameter modulation technique. It is found that both the methods are secure against ciphertext (return map) and plaintex attacks. We have illustrated these methods by means of the Lorenz system.

Chaotic Dynamics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: **The influence of grain shape on the agglomeration of polycrystalline films**, especially through the grain - boundary grooving mechanism. Specifically, the author studied the stability of films with different interface morphologies (rounded interfaces and polyhedral interfaces) under different conditions.

### Core problems of the paper

1. **The relationship between grain - boundary grooving and agglomeration**:
- Grain - boundary grooving refers to the grooves formed at the intersections of grain boundaries with interfaces or free surfaces. When the grooves are deep enough, grains may separate, leading to film agglomeration.
- The initial thickness of the film determines its stability. Thinner films and larger grains are more likely to agglomerate.

2. **The geometric influence of grain shape on stability**:
- For a rounded interface (arc of a circle), the grain volume \( V_{\text{circ}} \) can be expressed by the following formula:
\[
V_{\text{circ}} = \left( \pi - 2\theta - \sin 2\theta \right) \frac{r^2}{2}+ hw
\]
where \( r \) is the radius of curvature of the interface, \( h \) is the grain - boundary height, and \( w \) is the grain width.
- For a polyhedral interface (polygonal grain), the minimum initial film thickness \( h_{\text{poly}} \) is:
\[
\frac{h_{\text{poly}}}{w}=\frac{1}{4\tan\theta}\left[1 - \left( \frac{\ell}{w} \right)^2\right]
\]
where \( \ell \) is the length obtained by minimizing the total interface energy.

3. **The influence of interface anisotropy**:
- The anisotropy of interface energy will affect the chemical potential, thus changing the interface morphology. Even a very small energy difference may significantly affect the stability of grains.
- For polyhedral grains, the interface energy ratio \( \gamma_1/\gamma_2 \) and the grain - boundary energy ratio \( \gamma_{gb}/(2\gamma_i) \) determine the stability of grains.

### Key conclusions

- **Geometric effect**: Under the same conditions, polyhedral films usually need to be thicker to avoid agglomeration because their geometric shape is less stable than that of rounded interfaces.
- **Energy difference**: If there is a slight energy difference between different interfaces, polyhedral films may be very unstable and may agglomerate at any thickness; conversely, in some cases, polyhedral films may never form grooves and thus remain stable.
- **Parameter dependence**: The stability of grains mainly depends on \( \lambda \), that is, the ratio of \( \ell/w \), rather than directly on the grain - boundary angle \( \theta \).

In general, through theoretical models and mathematical derivations, this paper reveals the significant influence of grain shape and its interface energy characteristics on the agglomeration behavior of polycrystalline films and provides methods for evaluating and predicting film stability.