Abstract:In this work, the delay limited capacity (DLC) of orthogonal frequency division multiplexing (OFDM) systems is investigated. The analysis is organized into two parts. In the first part, the impact of system parameters on the OFDM DLC is analyzed in a general setting. The main results are that under weak assumptions the maximum achievable single user DLC is almost independent of the distribution of the path attenuations in the low signal-to-noise (SNR) region but depends strongly on the delay spread. In the high SNR region the roles are exchanged. Here, the impact of delay spread is negligible while the impact of the distribution becomes dominant. The relevant asymptotic quantities are derived without employing simplifying assumptions on the OFDM correlation structure. Moreover, for both cases it is shown that the DLC is maximized if the total channel energy is uniformly spread, i.e. the power delay profile is uniform. It is worth pointing out that since universal bounds are obtained the results can also be used for other classes of parallel channels with block fading characteristic. The second part extends the setting to the broadcast channel and studies the corresponding OFDM DLC BC region. An algorithm for computing the OFDM BC DLC region is presented. To derive simple but smart resource allocation strategies, the principle of rate water-filling employing order statistics is introduced. This yields analytical lower bounds on the OFDM DLC region based on orthogonal frequency division multiple access (OFDMA) and ordinal channel state information (CSI). Finally, the schemes are compared to an algorithm using full CSI.

The Delay-Limited Capacity Region of OFDM Broadcast Channels

Thermo-optic characterization of Yb:CaGdAlO 4 laser crystal

Optical Temperature Sensing Characteristics of Yb3+/Nd3+ Co-Doped YAG Single Crystal Fiber Based on Up-Conversion Luminescence

Characteristics of Cr3+:YAG single crystal optical fiber for fluorescence temperature sensor

High-sensitivity Ratiometric Thermometers of Yb 3+/er 3+/tm 3+Co-Doped LuScO 3 Single Crystal Fibers Based on Non-Thermally Coupled Energy Levels

Thermal distortions in high-power end-pumped Nd:YVO_4 crystals

Thermal Lensing in an End-Pumped Yb:KGW Slab Laser with High Power Single Emitter Diodes.

Thermal conductivity versus Yb3+ concentration in Yb:CALGO: A material for high power ultrafast laser

Numerical Analysis of Temperature Distributions in Yb-Doped Double-Clad Fiber Lasers with Consideration of Radiative Heat Transfer

Investigation of the lasing performance of a crystalline-coated Yb:YAG thin-disk directly bonded onto a silicon carbide heatsink

Sensitivity-enhanced Tm 3+ /yb 3+ Co-Doped YAG Single Crystal Optical Fiber Thermometry Based on Upconversion Emissions

Mapping Temperature Distribution Generated by Photothermal Conversion in Graphene Film Using Er,Yb:NaYF4 Nanoparticles Prepared by Microwave-Assisted Solvothermal Method

High-speed and high-resolution YAG fiber based distributed high temperature sensing system empowered by a 2D image restoration algorithm

Optical Temperature Sensing Characteristics of Sm3+ Doped YAG Single Crystal Fiber Based on Luminescence Emission

Thermal effect analysis on cuboid Pr:YLF crystals pumped by blue laser diodes

Fiber Thermometer Based on the Cross Detection of the Fluorescence Lifetime of Cr3+:YAG Crystal Fiber and Plank"s Blackbody Radiation from Cryogenic Up to 1400°C

Non-contact temperature field measurement of solids by infrared multispectral thermotransmittance

Infrared thermotransmittance-based temperature field measurements in semitransparent media

Compact and Sensitive Er 3+ /yb 3+ Co-Doped YAG Single Crystal Optical Fiber Thermometry Based on Up-Conversion Luminescence

Upconversion Luminescence and Effect of Pump Power on Optical Thermometry of Yb3+/Er3+ Co-Doped YOF Self-Crystallization Glass Ceramics

Characterization of an optical fiber thermometer using Tm3+:YAG crystal, based on the fluorescence lifetime approach