Abstract:The Protein-Le Chatelier (PLC) effects are investigated by using digital image correlation at a constant applied strain rate of 5.0010-3 s-1 and room temperature in Al-Mg alloys with Mg content values (wt.%) of 2.30, 4.57, 6.10 and 6.91 respectively in this study. Both the yield strength and the ultimate strength increase with increasing Mg content, which is generally called solution strengthening. Type of PLC band changes from A to B with increasing Mg content. In low Mg content (2.30%) alloy, the serration amplitude almost remains 1 MPa, while in each of high Mg content (4.57%, 6.10%, 6.91%) alloys it linearly increases with the strain increasing. The serration amplitude is found to increase with increasing Mg content and gradually reaches a saturated state. With the increase of Mg content, the period of PLC band for continuous propagation gradually reduces and the time when the PLC band location sudden jumps increases in the process of propagation. When the strain is small, the out-of-band deformation of alloy is inhomogeneous obviously. And the deformation inhomogeneity slightly decreases with increasing Mg content. DIC results indicate that the PLC bandwidth does not change with Mg content, while the maximum strain increment in the PLC band increases with increasing both Mg content and strain. Additionally, special periodic damped serrations are observed in the stress-time curve of the low Mg content (2.30%), the corresponding PLC band shows that the periodic changed serrations in the stress-time curve correspond to the transformation of the PLC band orientation. Besides, the PLC band propagates upward continuously both before and after the shift.

Comparative study of the Portevin-Le Chatelier effect in interstitial and substitutional alloy

The Portevin-Le Chatelier Effect in Al-Mg Alloy Investigated by Infrared Pyrometry

Effective dimensionality of the Portevin - Le Chatelier effect

On the Propagation and Pulsation of Portevin-Le Chatelier Deformation Bands: an Experimental Study with Digital Speckle Pattern Metrology

Recurrence analysis of the Portevin-Le Chatelier effect

Portevin-Le Chatelier Effect: a Poisson Process

EFFECT OF PRECIPITATE ON PLC EFFECT IN 2024 Al ALLoY

Multiscale Entropy Analysis of the Portevin-Le Chatelier Effect in an Al-2.5%Mg Alloy

Effect of Solute Concentration on Portevin-Le Chatelier Effect in Al-Cu Alloys

Multiscale Analysis And Numerical Modeling Of The Portevin-Le Chatelier Effect

On the spatio-temporal characteristics of the Portevin-Le Chatelier effect in aluminium alloy AA5182: An experimental and numerical study

Fracture behavior of a rapidly solidified thin-strip continuous cast AA5182 Al-Mg alloy with the Portevin-Le Chatelier effect under varying strain rates

In Situ Analysis of the Portevin-Le Chatelier Effect from Low to High-Entropy Alloy in Equal HfNbTaTiZr System

Spatiotemporal aspects of the Portevin–Le Chatelier effect in annealed and solution-treated aluminum alloys

Influence Of Solute Concentration On Plc Effect In Al-Cu Alloys

A Macroscopic Model for the Portevin-Le Chatelier Effect

The Effect of Solution Treatment on the Spatial Behavior of the Portevin-Le Chatelier Effect in Al-Cu Alloys

Experimental Investigation on the Influence of Mg Content on Portevin-Le Chatelier Effect in Al-Based Alloys by Using Digital Image Correlation

Numerical Analysis on the Spatiotemporal Characteristics of the Portevin-Le Chatelier Effect in Ti-12Mo Alloy

Characterization of Portevin–Le Chatelier Effect in Aluminum Alloy AA5052 under Strain-Controlled Tensile Test Via Digital Image Correlation and Acoustic Emission

The Influence of Temperature on the PLC Effect in Al-Mg Alloy