Abstract:There is an increasing need for lightweight structures in the transportation industry, and within these lightweight structures occupant safety is continually important to all stakeholders. Standard single and multi-material topology optimization (MMTO) techniques are effective for designing lightweight structures subjected to linear objectives and constraints but cannot consider crashworthiness. Crashworthiness must be evaluated using explicit dynamic simulation techniques, as a crash event contains geometric and material nonlinearities which cannot be captured by linear static finite element simulations. Explicit dynamic simulations prevent the calculation of sensitivity derivatives required for conventional gradient-based structural optimization strategies. This paper describes a design tool for multi-material topology optimization considering crashworthiness using the equivalent static load (ESL) method. The ESL method is used to generate linear static sub-problems which replicate the dynamic structural response of explicit dynamic crash simulations in the linear regime. The ESL sub-problems are input to a standard MMTO, optimized results from which are used as input for subsequent crash analyses to update the ESLs for additional sub-problems. The ESLs evolve as the design changes – convergence occurs when the design does not change significantly between subsequent sub-problem optimizations. The objective of this paper is to demonstrate a methodology for an efficient design tool for MMTO considering crashworthiness. Firstly, the ESL and competing methods for crashworthiness optimization are introduced and compared. Next a discussion of the tool’s operation flow as well as the sensitivity equations are presented along with two academic examples demonstrating its implementation. The design tool generates optimized multi-material designs which outperform single-material optimized designs in terms of mass by 7.5% and 17.6% in 2D and 3D models respectively when subjected to crash load cases.

Topology optimization for energy absorption of quasi-brittle structures undergoing dynamic fractures

Topology optimization for enhanced dynamic fracture resistance of structures

A novel topology optimization formulation for enhancing fracture resistance with a single quasi‐brittle material

Level-Set Topology Optimization for Ductile and Brittle Fracture Resistance Using the Phase-Field Method

The Path-Engulfment Method for Topology Optimization of Structures

Topology Optimization to Fracture Resistance: A Review and Recent Developments

On tailoring fracture resistance of brittle structures: A level set interface-enriched topology optimization approach

Structural design against brittle fracture: Optimizing energy release rate and experiment

Transient stress-constrained topology optimization of impacted structures

Topology optimization of damage‐resistant structures with a predefined load‐bearing capacity

Fracture resistance via topology optimisation

A SIMP-phase field topology optimization framework to maximize quasi-brittle fracture resistance of 2D and 3D composites

Topology optimization for transient response of structures subjected to dynamic loads

Topology Optimization with Frictional Self-Contact

Optimal Structures for Failure Resistance Under Impact

Fatigue-resistance topology optimization of continuum structure by penalizing the cumulative fatigue damage

Characterization of fracture in topology-optimized bio-inspired networks

Strength-induced peridynamic modeling and simulation of fractures in brittle materials

Multi-material topology optimization of adhesive backing layers via J-integral and strain energy minimizations

Multi-Material Topology Optimization Considering Crashworthiness

Coupling of bond-based peridynamics and continuous density-based topology optimization methods for effective design of three-dimensional structures with discontinuities