A practical phosphorus-based anode material for high-energy lithium-ion batteries

Rachid Amine,Amine Daali,Xinwei Zhou,Xiang Liu,Yuzi Liu,Yang Ren,Xiaoyi Zhang,Likun Zhu,Said Al-Hallaj,Zonghai Chen,Gui-Liang Xu,Khalil Amine

DOI: https://doi.org/10.1016/j.nanoen.2020.104849

IF: 17.6

2020-08-01

Nano Energy

Abstract:State-of-the-art lithium-ion batteries cannot satisfy the increasing energy demand worldwide because of the low specific capacity of the graphite anode. Silicon and phosphorus both show much higher specific capacity; however, their practical use is significantly hindered by their large volume changes during charge/discharge. Although significant efforts have been made to improve their cycle life, the initial coulombic efficiencies of the reported Si-based and P-based anodes are still unsatisfactory (<90%). Here, by using a scalable high-energy ball milling approach, we report a practical hierarchical micro/nanostructured P-based anode material for high-energy lithium-ion batteries, which possesses a high initial coulombic efficiency of 91% and high specific capacity of ~2500 mAh g−1 together with long cycle life and fast charging capability. In situ high-energy X-ray diffraction and in situ single-particle charging/discharging were used to understand its superior lithium storage performance. Moreover, proof-of-concept full-cell lithium-ion batteries using such an anode and a LiNi0.6Co0.2Mn0.2O2 cathode were assembled to show their practical use. The findings presented here can serve as a good guideline for the future design of high-performance anode materials for lithium-ion batteries.

materials science, multidisciplinary,chemistry, physical,physics, applied,nanoscience & nanotechnology

What problem does this paper attempt to address?

The paper primarily aims to address the issue of low specific capacity of graphite anode materials in current lithium-ion batteries (LIBs), which limits the energy density and power density of the batteries. The paper proposes a novel phosphorus-based anode material, aiming to develop high-energy-density lithium-ion batteries.

Specifically, the paper addresses the following key issues:
1. **Improving Initial Coulombic Efficiency (ICE)**: The initial Coulombic efficiency of traditional silicon-based or phosphorus-based anode materials is often below 90%, which limits their practical application. This paper achieves a high initial Coulombic efficiency (approximately 91%) by developing a hierarchical micro-nano structured phosphorus-based anode material, which is crucial for enhancing the overall performance of the battery.
2. **Mitigating Volume Changes**: Silicon and phosphorus undergo significant volume changes (over 300%) during charge and discharge cycles, leading to material fracture and degradation of electrochemical performance. The paper effectively mitigates this issue by using a scalable high-energy ball milling method to prepare black phosphorus/carbon composites.
3. **Achieving High Specific Capacity and Long Cycle Life**: The proposed anode material not only has a high initial Coulombic efficiency but also exhibits a high specific capacity of up to ~2500 mAh/g and excellent cycling stability (maintaining a specific capacity of over 2000 mAh/g after 100 cycles).
4. **Validating Full-Cell Performance**: To demonstrate the practical application potential of this anode material, the researchers assembled full cells using this anode material with commercial LiNi0.6Co0.2Mn0.2O2 cathode material and confirmed its good electrochemical performance.

In summary, this research proposes effective solutions to the problems existing in current lithium-ion battery anode materials, which is of great significance for promoting the development of high-energy-density lithium-ion batteries.