Abstract:Lithium-ion batteries (LiBs) have been widely applied in electric vehicles (EVs) and energy storage devices. The battery thermal management system (BTMS) critically impacts the safety and degradation of LiBs. Phase change material (PCM) is a promising passive BTMS solution owing to its high latent heat and non-parasitic power consumption requirements. In this paper, paraffin (PA) as the PCM was embedded in the copper foam to enhance the heat dissipation of the cooling material. The thermal responses of the battery module were comparatively investigated under different thermal management solutions, including natural air, pure PCM, and copper foam-PCM. A battery module consisting of 16 thermal dummy cells (TDC) was designed, built, and calibrated to replace real commercial 21,700 NMC battery cells. The findings indicate that the proposed copper foam-PCM solution effectively enhances heat dissipation and improves the temperature uniformity of the battery module. For instance, in the condition of intensive operation (60% depth of discharge and 3C discharge), copper foam-PCM composite material reduces the maximum temperature rise from 57.4 °C to 51.4 °C (-10.4%) compared to pure PCM. At ambient temperatures of 25 °C and 35 °C, the temperature inhomogeneity of the battery module with copper foam-PCM is maintained within 5 °C and 2 °C, respectively. Besides, the effect of copper foam-PCM cooling on the cell-to-pack conversion efficiency was evaluated. The gravimetric cell-to-pack ratio (GCTP) and volumetric cell-to-pack ratio (VCTP) of the battery pack employing the proposed BTMS reached 53.1% and 45.6%, respectively.

Experimental and numerical simulation study on the integrated thermal management system for electric vehicles

Heating Strategy for Electric Vehicular Battery Pack Based on CFD Analysis

Experimental and Numerical Investigation on an Integrated Thermal Management System for the Li-Ion Battery Module with Phase Change Material

Numerical and Experimental Investigation on the Performance of Battery Thermal Management System Based on Micro Heat Pipe Array

Thermal Management of a Li-Ion Battery for Electric Vehicles Using PCM and Water-Cooling Board

Performance simulation of a heat pipe and refrigerant-based lithium-ion battery thermal management system coupled with electric vehicle air-conditioning

Experimental study on the performance of vehicle integrated thermal management system for pure electric vehicles

Experimental Investigation on the Thermal Performance of Heat Pipe-Assisted Phase Change Material Based Battery Thermal Management System

A Low-Cost and Lightweight Thermal Management System for Lithium-Ion Battery Modules Based on Composite PCM under Normal EV Operating Conditions

Experimental Investigation on Thermal Management of Electric Vehicle Battery Module with Paraffin/Expanded Graphite Composite Phase Change Material

Thermal Management Evaluation of Li-ion Battery Employing Multiple Phase Change Materials Integrated Thin Heat Sinks for Hybrid Electric Vehicles

Parameter optimization and sensitivity analysis of a Lithium-ion battery thermal management system integrated with composite phase change material

Experimental Study of Battery Passive Thermal Management System Using Copper Foam-Based Phase Change Materials

Experimental and numerical study of lithium-ion battery thermal management system using composite phase change material and liquid cooling

Experimental and numerical investigations of lithium-ion battery thermal management using flat heat pipe and phase change material

Experimental and Simulative Investigation on Battery Thermal Management System with Structural Optimization of Composite Phase Change Material

Thermal performance of a lithium-ion battery thermal management system with vapor chamber and minichannel cold plate

Performance of a Combined Battery Thermal Management System with Dual-Layer Phase Change Materials and Air Cooling Technologies

Research on temperature control performance of battery thermal management system composited with multi-channel parallel liquid cooling and air cooling

Optimizing a direct flow cooling battery thermal management with bod baffles for electric vehicles: An experimental and simulation study

Experiments and Simulation on the Performance of a Liquid-Cooling Thermal Management System including Composite Silica Gel and Mini-Channel Cold Plates for a Battery Module