Abstract:Gas Electron Multiplier (GEM) detectors are crucial for enabling high-resolution X-ray polarisation of astrophysical sources when coupled to custom pixel readout ASIC in Gas Pixel Detectors (GPD), as in the Imaging X-ray Polarimetry Explorer (IXPE), the Polarlight cubesat pathfinder and the PFA telescope onboard the future large enhanced X-ray Timing and Polarimetry (eXTP) Chinese mission. The R&D efforts of the IXPE collaboration have resulted in mature GPD technology. However, limitations in the classical wet-etch or laser-drilled fabrication process of GEMs motivated our exploration of alternative methods. This work focuses on investigating a plasma-based etching approach for fabricating GEM patterns at Fondazione Bruno Kessler (FBK). The objective is to improve the aspect ratio of the GEM holes, to mitigate the charging of the GEM dielectric which generates rate-dependent gain changes. Unlike the traditional wet-etch process, Reactive Ion Etching (RIE) enables more vertical etching profiles and thus better aspect ratios. Moreover, the RIE process promises to overcome non-uniformities in the GEM hole patterns which are believed to cause systemic effects in the azimuthal response of GPDs equipped with either laser-drilled or wet-etch GEMs. We present a GEM geometry with 20 micrometers in diameter and 50 micrometers pitch, accompanied by extensive characterisation (SEM and PFIB) of the structural features and aspect ratios. The collaboration with INFN Pisa and Turin enabled us to compare the electrical properties of these detectors and test their performance in their use as electron multipliers in GPDs. Although this R&D work is in its initial stages, it holds promise for enhancing the sensitivity of the IXPE mission in X-ray polarimetry measurements through GEM pattern with more vertical hole profiles.

Gas Pixel Detectors for X-ray Polarimetry applications

Assembly and Test of the Gas Pixel Detector for X-ray Polarimetry

Spectral and polarimetric characterization of the Gas Pixel Detector filled with dimethyl ether

Equalizing the Pixel Response of the Imaging Photoelectric Polarimeter On-Board the IXPE Mission

The position resolution of the Gas Microchannel plate Pixel Detector

Development and preliminary tests of resistive microdot and microstrip detectors

XPOL-III: a New-Generation VLSI CMOS ASIC for High-Throughput X-ray Polarimetry

Operation and performance of microhexcavity pixel detector in gas discharge and avalanche mode

Development of a new generation of micropattern gaseous detectors for high energy physics, astrophysics and environmental applications

Development of innovative micropattern gaseous detectors with resistive electrodes and first results of their applications

PolarLight: a CubeSat X-ray polarimeter based on the gas pixel detector

Design and Testing of a 0.8 V Low-voltage High-rate Prototype Readout ASIC for the Micro-Pattern Gas Detector

Fundamentals of Gas Micropattern Detectors

Pixelized Gas Micro-well Detectors for Advanced Gamma-ray Telescopes

A Concept for a High-Energy Gamma-ray Polarimeter

Perspectives of Micro-Pattern Gaseous Detector Technologies for Future Physics Projects

Characterisation of resistive MPGDs with 2D readout

A Novel Method of Encoded Multiplexing Readout for Micro-Pattern Gas Detectors

Plasma-Based Etching Approach for GEM Detector Microfabrication at FBK for X-ray polarimetry in space