Observation of Interband Two-Photon Absorption Saturation in CdS Nanocrystals

Jun He,Jun Mi,Heping Li,Wei Ji

DOI: https://doi.org/10.48550/arXiv.cond-mat/0510402

2005-10-15

Abstract:We report the observation of interband two-photon absorption (TPA) saturation in cadmium sulfide nanocrystals (CdS NCs) under intense femtosecond laser excitation with 1.6-eV photon energy. The observation has been compared to interband TPA saturation in bulk CdS under the same experimental conditions. By using both Z-scan technique and transient absorption measurement, the saturation intensity has been determined to be 190 GW/cm^2 for CdS NCs of 4-nm diameter, which shows two orders of magnitude greater than that for CdS bulk crystal. The results are in agreement with an inhomogeneously-broadened, saturated TPA model.

Materials Science

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to observe and measure the inter - band two - photon absorption (TPA) saturation phenomenon in cadmium sulfide nanocrystals (CdS NCs) and compare it with the bulk cadmium sulfide (CdS) material. Specifically, the author hopes to determine the following points through experiments:

1. **TPA Saturation Intensity**: Under high - intensity femtosecond laser excitation, what is the TPA saturation intensity in CdS nanocrystals? This helps to understand the nonlinear optical behavior of these nanomaterials at high excitation intensities.

2. **Differences between Quantum Dots and Bulk Materials**: Compare the TPA saturation characteristics of CdS nanocrystals and bulk CdS under the same experimental conditions, and reveal the influence of the quantum confinement effect on TPA saturation.

3. **Model Verification**: Verify the theoretical model through experimental data, especially whether the inhomogeneously broadened saturated TPA model can explain the observed phenomena.

### Main Research Contents

- **Experimental Methods**:
- Use Z - scan technology and transient absorption measurement technology.
- The laser pulse energy used in the experiment is 1.6 eV, and the peak power density is as high as 500 GW/cm².

- **Experimental Results**:
- The measured TPA saturation intensity of CdS nanocrystals is 190 GW/cm², which is two orders of magnitude higher than the saturation intensity of bulk CdS (about 6 GW/cm²).
- The observed TPA saturation phenomenon conforms to the inhomogeneously broadened saturated TPA model.

- **Theoretical Analysis**:
- Explain the experimental results through numerical simulation and theoretical formulas. For example, the following formula is used to describe the TPA saturation intensity:

\[
I_s=\frac{\hbar\omega}{\pi\tau_p N_0 p(2\omega)}
\]

where \( g_k \) and \( g_n \) are the degeneracies of the upper and lower energy levels, \( \tau_p \) is the half - width of the femtosecond laser pulse, \( N_0 \) is the concentration of nanocrystals, \( p(2\omega) \) is the probability of the homogeneous absorption category, and \( \Delta\omega \) is related to the dephasing time.

### Conclusion

This study confirms that a higher excitation intensity is required to achieve TPA saturation in CdS nanocrystals, which is mainly due to the change in the electronic structure caused by the quantum confinement effect. This finding is of great significance for applications such as three - dimensional imaging and optical limiting based on quantum dots.