B.B. Blinov,R.N. Kohn Jr.,M.J. Madsen,P. Maunz,D.L. Moehring,C. Monroe
Abstract:We demonstrate broadband laser cooling of atomic ions in an rf trap using ultrafast pulses from a modelocked laser. The temperature of a single ion is measured by observing the size of a time-averaged image of the ion in the known harmonic trap potential. While the lowest observed temperature was only about 1 K, this method efficiently cools very hot atoms and can sufficiently localize trapped atoms to produce near diffraction-limited atomic images.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: The currently widely - used sensitivity criterion has flaws when measuring the level of fine - tuning, especially during the renormalization process. Specifically:
1. **Limitations of the Sensitivity Criterion**:
- The sensitivity criterion cannot correctly reflect the degree of fine - tuning, especially when dealing with parameters of different dimensions.
- The sensitivity criterion assumes that Lagrangian parameters are uniformly distributed within a certain range and ignores non - monotonic relationships in some special cases.
- The sensitivity criterion can only reflect the overall average fine - tuning level of the parameter range, and cannot accurately describe the fine - tuning degree of specific parameter values.
2. **Fine - Tuning Problems in Renormalization**:
- In the renormalization process, the relationship between high - energy - scale parameters (such as the grand unified scale) and low - energy - scale parameters (such as the weak interaction scale) leads to a sharp reduction in the parameter range, thus creating a fine - tuning problem.
- For example, in the φ^4 model, the bare mass \(m_0\) and the cutoff energy scale \(\Lambda\) are both approximately \(10^{18}\) GeV. In order to obtain a small weak - scale renormalized mass \(m\), fine - tuning is required.
3. **Fine - Tuning Problems in the Hybrid Mechanism**:
- In the hybrid mechanism, the linear or approximately linear relationship between input parameters (such as \(M_H^D, M_H^U, \mu\)) and output parameters (such as \(M_Z\)) leads to a fine - tuning problem.
- For example, in the MSSM model, the mass \(M_Z\) of the Z boson is determined by multiple large parameters, while the actually observed \(M_Z\) is only about 100 GeV, so fine - tuning is required.
4. **Proposing a New Criterion**:
- The author points out three implicit assumptions of the sensitivity criterion and analyzes the reasons for its failure, mainly due to dimensional effects and the sharp reduction in the parameter range.
- To solve these problems, the author proposes a new criterion, which takes into account the different dimensional effects of parameters and uses probability density instead of total probability to measure the fine - tuning level.
5. **The New Fine - Tuning Criterion**:
- The new criterion avoids the problems in the sensitivity criterion by directly comparing the rate of change of parameters \(\frac{\delta y}{\delta x}\) and considering the dimensional - effect factor \(\Delta\).
- The new fine - tuning measurement formula is:
\[
\lambda=\ln\left(\sum\left|\frac{1}{\Delta_0}\frac{\delta y}{\delta x}\right|\right)
\]
- Where \(\Delta_0\) is the dimensional - effect factor at the grand unified scale, and \(\lambda\) is a dimensionless parameter that reflects the difficulty of choosing a specific weak - scale value.
6. **Defining the Maximum Tolerable \(\lambda\)**:
- For \(\lambda < 0\), the system is considered insensitive to initial conditions, that is, not fine - tuned.
- For \(\lambda> 0\), considering the limited parameter running range in high - energy physics, the system is considered fine - tuned only when \(\lambda\) is relatively large.
- Based on probability theory, \(P\leq0.05\) is usually defined as the upper limit of a small - probability event, which is used as the upper limit of the fine - tuning level.
In summary, this paper aims to propose a more reliable new criterion to measure the fine - tuning problem, especially in the applications of renormalization and the hybrid mechanism, by analyzing the deficiencies of the existing sensitivity criterion.