Abstract:Introduction Structural transformations in titanium have received a great deal of experimental and theoretical attention. Under pressure, titanium transforms from the hexagonal-closedpacked (hcp) structure to the high-pressure omega phase. This phase transition from hcp (α) to omega (ω) is martensitic. Martensitic transformations are abundant in the nature and have tremendous scientific and technological interest. In particular, the pressure-induced martensitic α → ω transformation in pure titanium (Ti) has significant implications in the aerospace industry because the ω phase formation affects the toughness and ductility of Ti. The occurrence of the pressure-driven α → ω transformation was first observed by Jamieson [13] and has since been studied extensively. Room temperature (RT) high-pressure studies of the α → ω transition show a large hysteresis, with the high-pressure ω phase being retained after pressure is released [2, 3]. The onset of the transition has been observed over a wide range of pressures from 2.9 GPa [4] to 11 GPa [5]. One of the factors that could be responsible for this scatter in the observed transition pressure (Pα→ω) is possibly the variation in the non-hydrostatic conditions in different experiments. However, the combined results from different experiments are inconsistent with this fact. Then the question is whether the shear stress explanation is correct and whether other factors play a role in the transition. To answer this question, we conducted a series of experiments in a diamond-anvil cell (DAC) using different pressure media. In this study, we examined the effects of uniaxial stresses on the α → ω transition of Ti using synchrotron xray powder diffraction. Experiments were performed using a DAC and four different pressure media, which provided different hydrostatic conditions. We clearly demonstrated that the presence of uniaxial stresses has a significant effect on the structural stability of Ti. We also observed that shortterm laser-heating of Ti lowers Pα→ω.

Systematic pathway generation and sorting in martensitic transformations: Titanium alpha to omega

Impurities block the alpha to omega martensitic transformation in titanium

Pathways to Titanium Martensite

lpha to O mega Ma rtensitic T ransformation

Atomistic simulation of martensite microstructural evolution during temperature driven $β\rightarrow α$ transition in pure titanium

X-ray diffraction of titanium under high pressures : a systematic analysis of the mechanism for the alpha to omega martensitic transformation

Theoretical Study on Martensitic-Type Transformation Path from Rutile Phase to Α-Pbo2 Phase of Ti2O*

An Empirical Tight-Binding Model for Titanium Phase Transformations

Phase transitions in titanium with an analytic bond-order potential

Phase Transformations in Titanium: Anisotropic Deformation of Ω Phase

Formation mechanism of lamellae during ¡ transformation in polycrystalline dual-phase Ti alloys

Transformation-induced plasticity in omega titanium

Electronic Structure Mechanism of Martensitic Phase Transformation in Binary Titanium Alloys

Novel transformation pathway and heterogeneous precipitate microstructure in Ti-alloys

Classical potential describes martensitic phase transformations between the $α$, $β$ and $ω$ titanium phases

Coherent and semicoherent $α$/$β$ interfaces in titanium: structure, thermodynamics, migration

Modeling and Simulation of Microstructure Evolution during Heat Treatment of Titanium Alloys

Mechanism of anatase-to-columbite TiO2 phase transformation via sheared phases: first-principles calculations and high-pressure torsion experiments

Coherent and semicoherent α / β interfaces in titanium: structure, thermodynamics, migration

The atomistic mechanism of hcp-to-bcc martensitic transformation in the Ti-Nb system revealed by molecular dynamics simulations.

On the Role of Chemical and Microstructural Heterogeneities in Multistage Martensitic Transformations