Abstract:Battery electric vehicles with multiple motors are characterized by actuator redundancy, which calls for application of instantaneously optimized distribution of motor/wheel torques, thus minimizing the energy consumption, i.e., maximizing the vehicle range. If the e-motors are equipped with disconnect clutches, the energy saving potential becomes even higher due to the avoidance of drag of inactive electric motors. However, in this case optimization through time and predictive control techniques should be used to provide globally minimal energy consumption. To this end, the paper proposes the following modeling, optimization, and model predictive control method for straight-line driving mode: (i) a dynamic backward-looking model of electric vehicle propelled by disconnect clutch-equipped four wheel motors, which takes into account the clutch synchronization-related drivetrain transient loss; (ii) globally optimal, dynamic programming (DP)-based off-line optimization of e-motor torque and clutch state control trajectories, and (iii) a model predictive torque vectoring control (MPC) strategy. The MPC strategy is verified by simulation for various certification driving cycles, and the results are compared with the DP-optimal benchmark for different values of a user-defined weighting coefficient, which penalizes frequent clutch disconnects for improved durability. The DP optimization results reveal that the energy consumption reduction achieved through the disconnect clutch functionality is up to 7%, on top of up to 5% reduction achieved by torque distribution itself. The MPC control strategy relying on the prediction horizon of 10 steps approach the DP energy consumption benchmark within the margin of 1%.

Research on TVD Control of Cornering Energy Consumption for Distributed Drive Electric Vehicles Based on PMP

An Aggressive Cornering Framework for Autonomous Vehicles Combining Trajectory Planning and Drift Control

A Fast Cornering Method Based on Model Predictive Control

Optimal Torque Vectoring Control for Distributed Drive Electric Vehicle.

Wheel Torque Distribution Control Strategy for Electric Vehicles Dynamic Performance with an Electric Torque Vectoring Drive-axle

The steering torque optimization and simulation verification of four-wheel-drive electric vehicles

Research on Multi-objective Optimization Torque Distribution Strategy for Distributed Drive Electric Vehicles Based on Dung Beetle Optimizer

An Energy-Saving Torque Vectoring Control Strategy for Electric Vehicles Considering Handling Stability Under Extreme Conditions

A review of drive torque distribution control for distributed drive electric vehicles

Torque Distribution Algorithm for Four In-wheel Motors Drive Electric Vehicle Based on Torque Vector Control

Wheel Torque Distribution of Four-Wheel-Drive Electric Vehicles Based on Multi-Objective Optimization

Optimal Torque Distribution Towards Power Saving for Distributed-driven Electric Vehicles

A Supervisory Control Strategy of Distributed Drive Electric Vehicles for Coordinating Handling, Lateral Stability, and Energy Efficiency

Design and application of a tire slip energy control scheme based on optimal guaranteed cost theory for four‐in‐wheel drive electric vehicles

Torque Vectoring Control as an Energy-Efficient Alternative to Vehicle Suspensions Tuning

Torque Distribution Strategy for Multi-PMSM Applications and Optimal Acceleration Control for Four-Wheel-Drive Electric Vehicles

A Torque Demand Model Predictive Control Approach for Driving Energy Optimization of Battery Electric Vehicle

Optimization of straight-line driving torque vectoring for energy-efficient operation of electric vehicles with multiple motors and disconnect clutches

An energy efficient intelligent torque vectoring approach based on fuzzy logic controller and neural network tire forces estimator

Trajectory optimization of an electric vehicle with minimum energy consumption using inverse dynamics model and servo constraints

Energy Efficient Pivot Steering Control of Differential Steering Vehicle