Abstract:CONSPECTUS: The conversion of solar energy to chemicals and the storage of this energy is one of the most promising routes to realizing a "carbon zero" society, for which particulate photocatalytic water splitting to produce hydrogen has been considered to be a clean potential route. For this purpose, many d(0) and d(10) metal-based nitrogen-incorporated oxide (including nitrogen-doped oxide and oxynitride) semiconductor photocatalysts have been developed as good candidates to harvest major visible regions of solar light and to exhibit suitable energy levels to drive water splitting. Compared to the oxide-type photocatalysts, valence bands of the nitrogen-incorporated oxide can be upshifted in consideration of the lower electronegativity of nitrogen atoms concerning the oxygen atoms. However, a high-temperature nitridation process was needed to introduce nitrogen atoms into the metal oxide lattice. Because of the poor charge balance of the N3- substitution for O2- and the strong reducing effect of the active nitrogen species at high temperature, the nitriding process tends to introduce both anionic vacancy defects as well as low-valent metal ion defects. In addition, the crystal size of (oxy)nitrides synthesized through high-temperature nitridation is generally large, and there is a lack of an effective charge-separation driving force within the bulk of the (oxy)nitrides. Because of the scarcity of surface catalytic sites, the photocatalytic activity of the (oxy)nitrides is rather low. Recently, our group has been devoted to addressing the above key challenges, especially for the d(0)-metal-based (oxy)nitrides. The new preparation routes and/or methods were carried out to enhance the nitration kinetics for the synthesis of (oxy)nitrides with low-defect concentrations and further fabricate some novel metal (oxy)nitrides. The doping strategies were developed to suppress the generation of low-valent metal ion defects. A one-pot nitridation strategy was developed to construct the type II heterostructures of two metal oxynitrides to enhance their charge separation, and a strategy for the surface modification of metal oxynitrides with inert metal oxides was developed to promote the surface hydrophilicity and the cocatalyst dispersion. In addition, an intimate and strengthened interface between the cocatalyst and the metal oxynitride photocatalyst was achieved by a sequential cocatalyst decoration method, and it was demonstrated that the strengthened interface is beneficial to enhancing the surface charge separation efficiency. Benefitting from these methods and strategies, some novel visible-light-responsive materials have been exploited for promising water splitting, and remarkably improved water splitting performances have been achieved on some typical d(0)-metal-based (oxy)nitrides regardless of H-2/O-2-evolving half-reactions and Z-scheme overall water splitting (Z-OWS) reactions. In this Account, we will give a concise summary of these methods and strategies, and the prospects of nitrogen-incorporated oxide photocatalysts for potential water splitting will be examined.

Defect Engineering of Two-dimensional Nb-based Oxynitrides for Visible-light-driven Water Splitting to Produce H2 and O2

Water splitting over new niobate photocatalysts with tungsten-bronze-type structure and effect of transition metal-doping

Defect Management of SrNbO 2 N through Zn Modification for Promoted Photocatalytic Water Oxidation

Optimized Band Gap and Fast Interlayer Charge Transfer in Two-Dimensional Perovskite Oxynitride Ba2NbO3N and Sr2NbO3/Ba2NbO3N Bonded Heterostructure Visible-Light Photocatalysts for Overall Water Splitting.

Single-Crystalline LaTiO2N Nanosheets with Regulated Defects for Photocatalytic Overall Water Splitting under Visible Light Up to 600 Nm

Facile Synthesis of NaNbxTa1-xO3 with Abundant Oxygen Vacancies for Photocatalytic Hydrogen Evolution Without Co-Catalyst

CO 2 Adsorption-Mediated Oxygen Defects for Photothermal Catalysis Self-Decomposition over Low-Crystalline Nb 2 O 5 Nanoribbons

Nitrogen-doped Layered Oxide Sr5Ta4O15−xNx for Water Reduction and Oxidation under Visible Light Irradiation

Bandgap and Defects Regulation of La2−xAxNi1−yByO4+δ (A = K, Sr, B = Co, Mn) Ruddlesden-Popper Type Perovskites for Efficient Photocatalytic Hydrogen Evolution

Defect Engineering in 0D/2D S-Scheme Heterojunction Photocatalysts for Water Activation: Synergistic Roles of Nickel Doping and Oxygen Vacancy.

Photocatalytic water oxidation over LaWO0.6N2.4 mesoporous single crystals under visible and near-infrared light illumination

Facile Fabrication of N‐Doped K2Nb2O6 Nanocrystals with Defective Pyrochlore Structure for Improved Visible‐Light Photocatalytic Hydrogen Production

The substitution effect of tantalum on the visible-light-driven water reduction activity of SrNbO2N photocatalyst

Designing Visible-Light-responsive La2Ti2O7 Photocatalysts by Surface Co-Doping of Nonmetal and Metal Combinations

The contrasting effect of the Ta/Nb ratio in (111)-layered B-site deficient hexagonal perovskite Ba5Nb4-xTaxO15 crystals on visible-light-induced photocatalytic water oxidation activity of their oxynitride derivatives.

The Role of Lattice Defects on the Optical Properties of TiO2 Nanotube Arrays for Synergistic Water Splitting

Strategies and Methods of Modulating Nitrogen-Incorporated Oxide Photocatalysts for Promoted Water Splitting

Realizing efficient photocatalytic water splitting over Mg-modified BaNbO 2 N under visible light illumination

K4ce2m10o30 (M = Ta, Nb) As Visible Light-Driven Photocatalysts for Hydrogen Evolution from Water Decomposition

Photocatalytic H-2 or O-2 Evolution over A-Site Deficient Perovskite-Type Compounds La1/3mo3 (M = Nb, Ta) from Aqueous Solutions

Nanostructured (oxy)nitrides controllably synthesized by flux-assisted nitridation for promoted photocatalytic water splitting