Abstract:By photodeposition of CrOx on SrTiO3-based semiconductors doped with aliovalent Mg(II) and functionalized with Ni/NiOx catalytic nanoparticles (economically significantly more viable than commonly used Rh catalysts), an increase in apparent quantum yield (AQYs) from ∼10 to 26% in overall water splitting was obtained. More importantly, deposition of CrOx also significantly enhances the stability of Ni/NiO nanoparticles in the production of hydrogen, allowing sustained operation, even in intermittent cycles of illumination. In situ elemental analysis of the water constituents during or after photocatalysis by inductively coupled plasma mass spectrometry/optical emission spectrometry shows that after CrOx deposition, dissolution of Ni ions from Ni/NiOx-Mg:SrTiO3 is significantly suppressed, in agreement with the stabilizing effect observed, when both Mg dopant and CrOx are present. State-of-the-art electron microscopy and energy-dispersive X-ray spectroscopy (EDX) and electron energy-loss spectroscopy (EELS) analyses demonstrate that upon preparation, CrOx is photodeposited in the vicinity of several, but not all, Ni/NiOx particles. This implies the formation of a Ni–Cr mixed metal oxide, which is highly effective in water reduction. Inhomogeneities in the interfacial contact, evident from differences in contact angles between Ni/NiOx particles and the Mg:SrTiO3 semiconductor, likely affect the probability of reduction of Cr(VI) species during synthesis by photodeposition, explaining the observed inhomogeneity in the spatial CrOx distribution. Furthermore, by comparison with undoped SrTiO3, Mg-doping appears essential to provide such favorable interfacial contact and to establish the beneficial effect of CrOx. This study suggests that the performance of semiconductors can be significantly improved if inhomogeneities in interfacial contact between semiconductors and highly effective catalytic nanoparticles can be resolved by (surface) doping and improved synthesis protocols.This article has not yet been cited by other publications.

Fluorine Passivated Perovskite SrNbO2N Photocatalyst for Robust Sunlight‐Driven Water Splitting

Defect Management of SrNbO 2 N through Zn Modification for Promoted Photocatalytic Water Oxidation

Enhanced photoelectrochemical water-splitting performance of SrNbO<sub>2</sub>N photoanodes using flux-assisted synthesis method and surface defect management

Vertical SrNbO 2 N Nanorod Arrays for Solar‐Driven Photoelectrochemical Water Splitting

Optimized Band Gap and Fast Interlayer Charge Transfer in Two-Dimensional Perovskite Oxynitride Ba2NbO3N and Sr2NbO3/Ba2NbO3N Bonded Heterostructure Visible-Light Photocatalysts for Overall Water Splitting.

A Perovskite Nanorod As Bifunctional Electrocatalyst for Overall Water Splitting

Nanostructured (oxy)nitrides controllably synthesized by flux-assisted nitridation for promoted photocatalytic water splitting

Nanoscale Lamination Effect by Nitrogen-Deficient Polymeric Carbon Nitride Growth on Polyhedral SrTiO3 for Photocatalytic Overall Water Splitting: Synergy Mechanism of Internal Electrical Field Modulation

Improved Photoelectrochemical Water Splitting of CaNbO2N Photoanodes by Co-Pi Photodeposition and Surface Passivation

Efficient electrocatalyst for solar-driven electrolytic water splitting: Phosphorus (P) and niobium (Nb) co-doped NiFe 2 O 4 nanosheet

Surface Modifications of Layered Perovskite Oxysulfide Photocatalyst Y2Ti2O5S2 to Enhance Visible‐Light‐Driven Water Splitting

Single-Crystalline LaTiO2N Nanosheets with Regulated Defects for Photocatalytic Overall Water Splitting under Visible Light Up to 600 Nm

Engineering Single-Atomic Ni-N4-O Sites on Semiconductor Photoanodes for High-Performance Photoelectrochemical Water Splitting

Ni Single Atoms Anchored on Nitrogen-Doped Graphene As H2-Evolution Cocatalyst of SrTiO3(Al)/CoOx for Photocatalytic Overall Water Splitting

MOF‐Based Transparent Passivation Layer Modified ZnO Nanorod Arrays for Enhanced Photo‐Electrochemical Water Splitting

CrO x -Mediated Performance Enhancement of Ni/NiO-Mg:SrTiO 3 in Photocatalytic Water Splitting

Engineering Single-Atomic Ni-N 4 -O Sites on Semiconductor Photoanodes for High-Performance Photoelectrochemical Water Splitting

Sr2NiWO6 Double Perovskite Oxide As a Novel Visible-Light-Responsive Water Oxidation Photocatalyst

NiO(x)-Fe2O3-coated P-Si Photocathodes for Enhanced Solar Water Splitting in Neutral Ph Water.

Nitrogen-doped Layered Oxide Sr5Ta4O15−xNx for Water Reduction and Oxidation under Visible Light Irradiation

Nanoparticulate TiN Loading to Promote Z‐Scheme Water Splitting Using a Narrow‐Bandgap Nonoxide‐Based Photocatalyst Sheet