Direct Electron Beam Writing of Silver-Based Nanostructures
Katja Höflich,Jakub Jurczyk,Yucheng Zhang,Marcos V. Puydinger dos Santos,Maximilian Götz,Carlos Guerra-Nuñez,James P. Best,Czeslaw Kapusta,Ivo Utke,Katja Höflich,Maximilian Götz,Carlos Guerra-Nuñez
DOI: https://doi.org/10.1021/acsami.7b04353
2017-07-05
Abstract:Direct writing utilizing a focused electron beam constitutes an interesting alternative to resist-based techniques, as it allows for precise and flexible growth onto any conductive substrate in a single-step process. One important challenge, however, is the identification of appropriate precursors which allow for deposition of the material of choice, e.g., for envisaged applications in nano-optics. In this regard the coinage metal silver is of particular interest since it shows a relatively high plasma frequency and, thus, excellent plasmonic properties in the visible range. By utilizing the precursor compound AgO<sub>2</sub>Me<sub>2</sub>Bu, direct writing of silver-based nanostructures via local electron beam induced deposition could be realized for the first time. Interestingly, the silver deposition was strongly dependent on electron dose; at low doses of 30 nC/μm<sup>2</sup> a dominant formation of pure silver crystals was observed, while at higher electron doses around 10<sup>4</sup> nC/μm<sup>2</sup> large carbon contents were measured. A scheme for the enhanced silver deposition under low electron fluxes by an electronic activation of precursor dissociation below thermal CVD temperature is proposed and validated using material characterization techniques. Finally, the knowledge gained was employed to fabricate well-defined two-dimensional deposits with maximized silver content approaching 75 at. %, which was achieved by proper adjustment of the deposition parameters. The corresponding deposits consist of plasmonically active silver crystallites and demonstrate a pronounced Raman signal enhancement of the carbonaceous matrix.
materials science, multidisciplinary,nanoscience & nanotechnology